Jump to content
SAU Community

Recommended Posts

yes it was sad , they all asked how there times were and I said that Stewie in a stock std road GTR with crap tyres ( who was instructing today btw ) posted a time about 2 secs quicker than the best rex they had there.

Hate to burst the bubble but they ain't that quick and under steer too much:D

Cheers

Ken

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by Micko

Romour has it that if the weather isn't too bad tomorrow there might be a cruise happening.

If so, are you going to be able to make it?

btw - I put some BCPR7's in today. Car feels stronger, just gotta be careful not to get carried away with the higher rev limit...

No worries Adam....

Cheers

Ken

not much bud - just got home from watching the new matrix movie - i loved it.. everyone else hated it.. wierd... i guess it wasn't a holiwood formula movie so it didn't get props from many...

u guys have that dinner tonight?

somehow i don't think the weather is going to get any better bud...

so did you change the exhaust timing with the gear? think it makes much diff? it's hard for me to tell cause i did the elec boost controller, dump and pulley all at the same time..

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I've been doing some looking around and honestly was just considering throwing a new rack at it. I saw that the dmax silvia rack bolts up into the 33 with the silvia bushings but not sure if the high pressure lines will sit in the correct spot. I believe other version of the 33 rack are the same/similar to the racks that can be opened up without as much fuss so I assume the dmax rack would fit but any ideas?
    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
×
×
  • Create New...