Jump to content
SAU Community

Recommended Posts

oooo we going to have a bitch fight - u slap me i slap u back haha

hehe my dad asked how it went and he was disappointed with what it made too. I just do tell him these things to see if i can inspire him to make my car faster - he will have to if ben gets one!

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Morning Bam bam wassup?

Oh get this remember that thing i worked on all last week? I gave it to the boss this morning and he sez

"whats this? "

"the report u asked for"

"i wanted the last financial year"

"yeh 2001-2002 right"

"nahh 2002-2003"

So here i go again, its not even the end of teh year, am i wrong? last financial year is 2001-2002 right huh uhh?

Originally posted by G0DF4Th3R

whuts a compression test and where can we get this done and what to look out for and how much will it cost and how long will it take and will you clean my room?

:) good one m8, u should start a thread!!!!:) get out the phone book and do a ringaround

hehe - yeah bambam i know but i have to save for europe or i'll incur my friends wrath!

Paul i aint paying for it - but its the only way u going to get anymore power out of it - i knew this day would come!

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...