Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

4 hours?? ack!

Mel n I went and had lunch at Little Creatures Brewery - bottle of wine later - we decided to go see a movie ..... but Bruce Almighty didnt start for an hour ...... so we proceeded to the pub for more drinking :)

Yes thanks niz.. I CAN EAT YAY!!!! Now that im eating, antibiotics are working feeling much better. Still a bit sore but i will be for the next few weeks.

Sore throat niz? Try some diffram, Lozingers that have anti inflamitorys and anterseptic. They taste ok, but suck them right at the back of your mouth or your toung goes numb and when you talk you sound retared... lol.. ive done that lots whopsy!

haha Kyles sounds like the stuff the dentist numbs your mouth with :) i always talk retarded after the dentist - puts me in a bad mood! - glad ur feeling better :)

Bam .... i drink about as much as any person my age :(

watched the movie - all the best bits were in the clip tho :) so the movie was pretty lame after that.

i spilt beer on myself accidently before we went so threw out the movie i smelt like an alcho - i kep ttapping mel on the shoulder "hey mel - i smell like beer" 10 mins later "god damn i smell like beer" haha she didnt mind she was more pissed than me :)

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...