Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

paul - yes.

ok, need some quick input. I beleive we should do the cruise for a bluey day on Friday night on August the 8th.

that way we can have a representative from SAUWA and the other clubs involved go to the shave at Morley on Saturday and present the money we raised.

I will try and get this event onto PMFM for coverage? yay or ney?

also - Omni undercover as the meet point - at 8:00 for 8:40 depart?

i had the same trouble at the chamber of commerce (how come its only when i dont work with cars) on my last day my ex sent me a huge bunch of flowers and on the card it had "Phuck em" on it - made me burst out laughing and of coarse then everyone wanted to see what was on the card - so i showed them - i think i didnt make many friends that day but who cares - all these people are are total fake backstabbers.

yeah - she was worried about me leaving her name off a list .... these contact cards ive had trouble laminating .... and she couldnt even send the email to the correct person ..... i shouldnt of told her but i did it just ot annoy her - sent the email back saying um i think you got the wrong person ...... least she knows she got caught out bitching!

Good Morning/Afternoon Everyone...

How is everyone..... Boy the day is going quick.... I thought it must be about 11.00am and I looked at my watch just then because I was hungry and its already 3.00 oclock!!!!!

Where has my day gone :D

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...