Jump to content
SAU Community

Recommended Posts

Hey all. I just got my R33 gtst back the other day. I was in canberra and on friday night i got it. Went on the cruise and met people at the museum and all and it was fine. drove like it used to, if not a little better.

saturday morning it wouldnt start. it sounded like it was about to kick over everytime i tried, so we called the NRMA. a dude came out (in about 5 minutes when they quoted 60 - 90) and he said that the sat. dishes and transmitting towers can affect the alarm i have, and f**k it up. so he just undid the battery and put it back, and it started.

from berra i drove to wollongong. the car feels like its missing a beat somewhere. when i take off, the whole car kinda shakes, and you can here it grumble, similar to a V8. at high revs its much less noticable, but when im taking off or accelerating a bit hard it comes back.

then this morning i go to start it again and it wont kick over. the same as when it first happened.

my brother reckons it could be the ingnition coils or plugs or something. has anyone ever had this problem or know of what could be causing it? also, its just had a massive service, timing belt, all electric, fixed it idle problem etc.

can anyone shed some light???

thanks.

Link to comment
https://www.sau.com.au/forums/topic/92218-r33-problem-sluggish-feel/
Share on other sites

When my R33's coils began to play up, i only noticed misfiring after the car got hot (30min of driving) but i never had a problem with starting it... and there was a misfire through out the rev range especially around 4000rpm.. Theres a thread in the DIY forum on changing spark plugs in a R33...

http://www.skylinesaustralia.com/forums/in...19&hl=R33+spark

have a look at the thread and follow the instructions on removing your coil packs, check them for any hair line cracks (causes misfiring) a high quality duct tape can be used to tape up the cracks which will help them work better for a period of time... if this helps then you need new packs and their not cheap... also with my R33 i found i had a fowled up spark plug (due to the faulty coil packs) also caused misfiring... so check plugs and coil pack... if all looks fine then its something else... you problem sounds either fuel or electrical related...

Check the following:

1. Spark plugs

2. Coil packs

3. Fuel pump (can you hear it when accesories is turned on?)

4. Injectors (run high quality injector cleaner with full tank of premium)

5. Air flow Meter (make sure sensor wire is clean and dirt free)

I hope this helps! Tell us how you go...

Regards,

Sarkis

Edited by QRI05E

hahaha well if you had any rare vintage like a 350GT Mustang... it would appretiate 5 - 10Gs value every year!

At the end of the day we are driving almost 10yr old cars, these things are expected to happen and its better to fix them properly 1st time round so they last longer... Nissan do build one of the best sports cars in the world!

Regards,

Sarkis

  • 9 years later...

Similar but replaced with ls1 coils, afrs are 11/10.5 full load and new plugs tps cas afm. First start of a morning runs like shit, as soon as oil pressure reaches more than half way it idles like its dropped a cylinder or two. Once warm its fixed untill flat out 2nd to 3rd change then starts almost flooding and running rough.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • 12+ months passed so they have no obligation to do a warranty claim. It leaked from the rear circuit. Front circuit was fine, but I tried many times to bench-bleed and in-car bleed (wasted 1L of Penrite racing brake fluid) to no avail. Threw my old BM50 or whatever the standard R32 GT-R BMC is, brakes went back to normal. So from my very limited anecdotal experience, I cannot recommend HFM, even though a lot of their products looks good. Just my experience (I have a genuine Nissan BM57 in a box waiting to be installed now).
    • How dare you sell your unreliable Skyline and buy a reliable, Toyota/Yamaha car with a strong gearbox, torsen LSD and Toyota reliability. At least you won't need to worry about oil pumps, big catch can, oil restrictors, blowing off power steering belts, sheering off 3rd gear, failing ABS relays/pumps, etc.
    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
×
×
  • Create New...