Jump to content
SAU Community

Recommended Posts

hey guys, not a big deal but something i still would like to fix. just installed a new dvd player and moniter, when its all switched off you can hear the alternator whine through the headunit i think, but when switched on even with no volume it goes away. just wondering if you guys have any ideas, thanks.

Link to comment
https://www.sau.com.au/forums/topic/92293-funny-one/
Share on other sites

  • 2 weeks later...

i know if you have the alternator whine coming through your amp you run the rca lead and the power lead down different sides of the car... but dont know how u could apply this to your problem... a little food for thought

Link to comment
https://www.sau.com.au/forums/topic/92293-funny-one/#findComment-1683647
Share on other sites

thanks for your response, it does seem like some sort of interfearence problem. havent rechecked anything yet but will do soon after it goes back on the dyno. it isnt a daily driver and i only play with it when i have nothing to do so im not in a big rush. thanks.

Russell.

Link to comment
https://www.sau.com.au/forums/topic/92293-funny-one/#findComment-1684579
Share on other sites

get a new balist resistor for the back of you alternator its a little cylinder attached to it. Next bad earth somewhere (dirty) most likley your remote lead from head unit to amp. Next power cables to clost to speaker or rca leads. They pick up signals from power cables and play in the speakers

Link to comment
https://www.sau.com.au/forums/topic/92293-funny-one/#findComment-1694407
Share on other sites

if you havent had any problem's with whining in this car before and theres no-interferance anywhere from an outside source, its most likly a grounding problem as mentioned ealier, it could also be a power leak somewhere into either the ground loop or the 12+ loop, if re-grounding everything up mabye try running just one long wire from the gound of the dvd unit straight to the earth in the battery just temporaraly if the whine goes away its a problem with your ground loop, so try gorunding in a different spot or use a different route, if it still occurs it could be a 12+ problem which is more difficult to fix, if possible try a different power source, if all fail's find somone who has an ossiliscope thingy which meausers your power/ earth frequency's and try and source where the interfeerance is comming from, other than that mabye it is an alternator causeed problem, which i doubt if the sound does go away, another possibility is you may have your remote wire plugged (or any of the dvd wires) into the wrong spot and so it could cause some sort of feedback when the unit is off but then when it is turned this wire could react different with constant current running down it, i know i had this problem one time when i grouned a mates head unit up to what seemed to be an earth wire n turned out to be an accessory wire which stayed earth untill activated, if all fails try temporarly installing the dvd unit to an external sources (another car, or threw a computer -- or some sort of 12 power sorce) and make sure the gear isnt the problem

Link to comment
https://www.sau.com.au/forums/topic/92293-funny-one/#findComment-1698808
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Apologies for the long post, but needed somewhere to lay out the entire timeline of events and actions taken:   I've got an 89 GTR with a R34 RB in it. It's been running great all year, driven probably 500KM in the last month. It's not my daily driver, just a weekend fun car.    Build info: R34 RB26 - HKS 2.7 stroker kit, HKS adjustable cam gears, HKS turbo upgrades, Trust intercooler, R34 factory DENSO 440cc injectors, JUN chipped/tuned R32 ECU. All of this work was performed in Japan back in 2019.    Thursday 10/2/25 - It's a nice day and decided I'll drive it to work, I start it up in the garage and I notice it took a few extra cranks and sounded a bit funny. I figure maybe it was just because it was a pretty chilly morning. I pull it out into the driveway to warm up a bit before leaving. As I leave the driveway, it feels very off and sounds like a misfire. I pull it back in the garage to deal with after work and take the daily to work. I was able to diagnose it as a cylinder 5 misfire with the old spark plug test (unplugging each plug until a sound change with the engine running). I take off the whole ignition system, ignitor, plugs, spark. *Important note, it is still on the R32 ignition system with the separate ignitor system. I test each system with a multi-meter and nothing presents as a smoking gun. I put it all back together and it starts up no issue. I go ahead and order the PRP R35 ignition conversion kit. It should arrive today (10/13/25)   Friday 10/3/25 - Another nice day, car starts up great and drives great all day. Very pleased that everything seems to be OK   Sunday 10/5/25 - Decided I'll take it to play some golf, load up and drive to the course about 25 minutes away. Drives wonderful the whole way there, I pull in the parking lot and the engine completely comes to a stop. I do not recall if it sputtered at all, but just remember all of the sudden the engine was off. I roll it into a parking spot, try to crank it back on and nothing.  It'll crank and crank and not even try to start. End up getting it towed back to my house and push it up into the garage.    Items I have checked: Fuel in the tank Fuel Pump relay Fuel pump fuse  Spark Plugs & gap Coil packs Ignitor    I know the cylinders are getting fuel as the plugs smell like fuel after a start attempt. I tried spraying starter fluid into the manifold and cranking and not even a sputter.    I decided to do the live CAS test (removing the the CAS, ignition on and spinning the CAS stalk to see if the injectors pulse and spark is active). All of the injectors were pulsing and I have spark at the plug. The half-moon end of the CAS did seem very loose, I'm not sure how much play is supposed to be there, but it was more than I expected. There was no in/out play of the shaft, just the tip end that is pinned on had quite a bit of play.    CAS Play video   When I put the CAS back in, I stupidly did not re-time the engine. I know I need to do that tonight, however, I do not think it will start given it seemingly was not the issue. My plan is to do the PRP R35 coil kit and retime the engine at the same time.    I plan on ordering the Haltech Nexus Plug-in ECU once they are available again, but ideally would like to get this sorted before firing the parts cannon at it and potentially adding more variables.    Anything glaring that I am missing here, I'm a bit at a loss?          
    • Get it on a dyno. Get something logging Consult. Run it up and find out what is causing it.
    • Looking for a plenum for rb25 de+t neo  Not looking to push much power maybe 300kw at the wheels, is there much difference in flow for Freddy “Greddy style” compared to original Greddy or options like Proflow or Otaku garage?    I won’t be porting the de Neo head for now as I think it’ll be fine 280-300rwkw but appreciate the help and any experiences anyone has between them and any advice. Thanks  Looking at this plenum for now below 
    • engine wise almost no mods: stock ecu Greddy front mount intercooler Greddy forward facing intake w R33 TB stock fuel system, stock injectors, rail etc. Kakimoto racing hyper 3 inch exhaust system Apexi intake filter New NGK –R BCPRES (.8 gap) plugs  
    • Nice one @Pac - looks like a fair few 1600's there! 
×
×
  • Create New...