Jump to content
SAU Community

Recommended Posts

  • Replies 83
  • Created
  • Last Reply

Top Posters In This Topic

The Mixture is really dependent on how much you want to muck around with the engine tune. Toluene is less volitile and so tends to have cold start issues at low temps (after today it looks like theres no chance of that for a while).

For a straight replacement of bp 98 to drop the 'ping' factor, run around with about 10- 15% with a 95/96 octane fuel.

I run upto 30-35% for short periods. It cleans out your fuel system while its at it too. This requires a tune to suit.

There are probably others with experience around who might like to share their prefferences too.

The price for a tin is actually $32 now. Diggers brand. For a 20L drum it's $97. If people like to they can shop around for a hardware store willing to get it in regularly at a better price in my opinion the hardware store is charging abit much since they changed from being a Makit brand store.Even at $32 I preffer this over the 500ml octane bottle no brand comes even remotely close.

appart from more power. Toluene will increase the exhaust temps a tad but, it's lower volitility means much increased tollerence to pre-ignition. You run it a little on the rich side of 11:1 to be safe if your a backyarder playing with timing.

Oh and the catylitic converters don't like this additive for very long periods without appropriate tuning.

here is an old extract I have about it;

Toluene is a pure hydrocarbon (C7H8). i.e. it contains only hydrogen and carbon atoms. It belongs to a particular category of hydrocarbons called aromatic hydrocarbons. Complete combustion of toluene yields CO2 and H2O. This fact ensures that the entire emission control system such as the catalyst and oxygen sensor of your car is unaffected. There are no metallic compounds (lead, magnesium etc), no nitro compounds and no oxygen atoms in toluene. It is made up of exactly the same ingredients as ordinary gasoline. In fact it is one of the main ingredients of gasoline.

Toluene has a RON octane rating of 121 and a MON rating of 107, leading to a (R+M)/2 rating of 114. (R+M)/2 is how ordinary fuels are rated. Note that toluene has a sensitivity rating of 121-107=14. This compares favorably with alcohols which have sensitivities in the 20-30 range. The more sensitive a fuel is the more its performance degrades under load. Toluene's low sensitivity means that it is an excellent fuel for a heavily loaded engine.

Toluene is denser than ordinary gasoline (0.87 g/mL vs. 0.72-0.74) and contains more energy per unit volume. Thus combustion of toluene leads to more energy being liberated and thus more power generated. This is in contrast to oxygenated octane boosters like ethanol or MTBE which contain less energy per unit volume compared to gasoline. The higher heating value of toluene also means that the exhaust gases contain more kinetic energy, which in turn means that there is more energy to drive turbocharger vanes. In practical terms this is experienced as a faster onset of turbo boost.

have fun...

oh and it's deadly poison and you'll all die die die !!! HA HA HA!

Is there any octane boosters that you guys recommend. Also.. how much do I add to a full tank of petrol, do i go the premimum + octane booster or just get the shitter commoner fuel + octane booster. Just wondering how much I add to bring it up to, or better than ultimate 98

http://www.nitrous.com.au/products.html

Comes highly reccomended by a few garages. How good it really is, i don't know. I put 1/2 a bottle of yellow into my tank for the purpose of injector cleaning, but i don't feel any difference. LoL. Cause for all u know, it just the garage pushing their product (they stock it), and when they stock it, high chance they wanna earn ur $$. But hey, it's made in WA! Supports WA! LOL!!!

bp along orrong rd (pretty sure the is only one heading towards farmer freeway) has ultimate, and so does bp in bullcreek along perry ave..and u can save 4c a litre there too wif dewsons or supa valu dockets :(

jus shop around and luck :( sum places run out of premium not 98..and apparently shell's premium is 87..not 95 or 96. so it beats votex which is ova rated :D

Toluene rotting fuel lines:

............actually yes it does and your whole car will start rotting shortly afterwards and then the neigbours dog too but, no one liked it barking at night anyway so we are all happy again. Although without fuel lines and a car.

It also will cause you girlfriend to leave you and it will lose you your job.

..and apparently shell's premium is 87..not 95 or 96. so it beats votex which is ova rated :)

Nah your wrong dude, don't know where you got that info. I'm telling you all now.. normal unleaded petrol is 91-92 RON, most premiums are 95-96 (VORTEX is 96) and BP Ultimate is 98.

Octane booster is pretty much useless guys. Yeah it helps a bit and most of them also clean out injectors and prevent knocking etc. But wont give you much of a performance gain.

Say you fill up with VORTEX (96RON), and you add in some octance boost which gives you "7-8 points", this will make your petrol 96.7 - 96.8 RON.

BP Ultimate still leads with 98RON.

10 points of octane boost = 1 RON.

Hope this helps :P

Edited by Br4nchi3

even IF it were true that fuel lines rot from tolulene

compare the cost effectiveness of replacing fuel lines, o-rings and fuel pump, with

rebuild of engine

hmm, tough choice. Seriously guys, dont listen to old wives tales, I have used tolulene, Rev210 has used tolulene, I know many people that regularly use tolulene (with other additives like avgas :) ) and NOT ONE of them, nor me has had any problems with rotting fuel lines

Next time someone tells you it rots fuel lines, ask them if its from personal experience, if they say no - its just a rumour, if they say yes, ask them how long they were using it until the fuel lines rotted, what percentages, and how old the fuel lines were to start with. I am sure they will get very vague about their answers at this point.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Good tips, will get on those tomorrow. When doing the maintenance I did move a few of those connectors around, and things that are old tend to not like moving around. (Like me).
    • Don't try it. It will be shit. Better chance of damaging the engine than gaining any knowledge about the old one. Maybe, but unlikely, especially if the O2 sensor is working. You can use NissDataScan to look at the stock ECU.   Cleaning the AFM is seldom necessary and seldom helps. The R35 coil & loom conversion should eliminate dud coils or plugs. But as you still have misses - look to the plug where the coil loom connects to the engine loom, and the CAS plug. Need quality connections there. Also look to injector plugs. And the AFM plug while you're at it. Also look to whether your injectors are clean and flowing evenly. Get them out and onto a testbench.
    • Good to know, I feel like I am in for a rollercoaster ride that looks like a sine wave. 
    • You'll fit right in. Acceptance is the first step.
    • Hey folks. I've been lurking and browsing the forum for a while, since I got into my head that I wanted a skyline. Having purchased an overpriced completely stock GTT, (only "mods" it has is HKS pod filter and catback) now that it became legal in the US, it was all glorious and sututu noises here and there. But then I wanted to do things right and went to do basic maintenance. After all the fluids, filters done, I did the spark plugs, that's when the problems started.. First the car started spluttering at around 4.5k RPM. Which I gapped down the new plugs and that solved the sputter there, but the car now always misfires at idle with pops when lifting off and shifting 2nd to 3rd. Similar to the issues in this recent thread. I've been banging my head against the wall, reading the threads here and trying suggestions for a couple months now, so decided to start this one to explain exactly what I tried and what is going on. The symptoms of the issue: Idle and low revs misfiring intermittently. You can hear the exhaust tone change and the shakes on the shifter knob. It happens frequently, but doesn't seem to have a rhythm to it. Pops when backing off throttle. It pops and or burbles almost feels like it spits fire when it pops. (Happens mostly in 3rd gear at around 2k RPM). When under load and after 6k RPM, it also pops when shifting from 2nd to 3rd. There's a ticking noise at around 2k RPM in 2nd gear going downhill, seems unrelated though but I am out of educated and downright dumb guesses. Not noticeable lack of power when putting the car into load. The attempted diagnosis and solutions: Unplugging coils when the car is running This did nothing to change the idling and tone shift for every cylinder. Checking the exhaust headers with thermometer They all are within what I'd say it is margin of error of the laser thermometer New spark plugs Tossed two new sets, copper, iridium and using the old ones, still misfiring, even re gapped to 0.8mm, still same thing. MAF cleaned with the "specific" spray cleaner No changes in the issues what so ever. Brand new loom and r35 coil conversion (was going to add the r35 coils anyway) car runs arguably better, still misfires, but seems like does less frequently. Placebo? Code 21 now being thrown, thanks nissan gods. Removed the CAS to check the shaft for play or anything. CAS seems all fine, nothing that indicates any issue, visually speaking. Things to attempted next: Ordered a new MAF (chinesium from Amazon, to be able to return regardless of result). Fuel with proper gas, maybe it is this California water that they sell as gas that is to blame? Plugin the link ECU and check the info using the built in base map. Go back to BMW and eat my rob bearing breakfast without milky oil mixture.   Do any of you have experienced anything like this or have any suggestion?
×
×
  • Create New...