Jump to content
SAU Community

Recommended Posts

http://www.importforums.com/information.htm

the R32 GTST 400m times of 14.63???

mine has a zorst, running 10psi and remapped ECU and POD and would only just get into the 14s... some semi slicks as well and then maybe that time would be true... then again im not the best launcher in the world.

Link to comment
https://www.sau.com.au/forums/topic/9470-these-stats-cant-be-right/
Share on other sites

My GTS-4 Sedan Auto, Very stock (Just Cheap pod filter and cold air induction) has run a 15.4 in very hot conditions, after a few runs, I am very sure with a good launch and the right conditions I could run 15 flat.

A manual r32 GTS-t Coupe could run a 14.6.

Greg.

absolutely stock?

those times are meant to be for STOCK cars.... when i took mine the first time when all it had was a zorst and nothing else it ran a 15.5 on a coldish night... i spose with decent wheels it maybe able to do a 15.0 but that still isnt stock

Mine ran 14.6 with a cat back exhaust, blitz ECU, air pod, stock turbo, 11psi. This was on a night that i broke it on my 6th run, no compression in cylinder 6 (2 valves burnt). After fixing it we discovered that it had been running for a while with lower comp in that cylinder, so it was a tad down on power. Feels quicker now that its all fixed up.

If i tried again with a bit of practice I might get it down to a 14.4. While the figure the site stipulates is probably now a genuine stock time... its not THAT far off. However their weight listed is also a bit off the mark (i believe the 32 gtst weights 1350-80?)

Red17

But i dont see the point in hammering the car when I havent changed anything that would make it go any faster :)

I ran a 14.2 with cat back exhaust/filter and standard boost.!!

2.1 ish 60 foot. and I had ran a 1.9 earlier in the night. So theoretically it was good for a 14 flat if i could get the same launch..

With full exhaust/tune/pump/boost I am hoping for hi to maybe mid 13 with a good launch

Originally posted by Duncan

I ran 14.3 with stock zorst, stock airbox, stock everything except 9psi boost.  R33 gtst, we all know they are better :uh-huh:

butt uglier.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'll just leave this with, holy shit, those cars at work are awesome, and this will look wicked!
    • Could you modify this duct so instead it pushes the extra air through the radiator too and not down and out? For temps, I know it's not the greatest idea, but as a bit of a last resort, you could use a very intermittent misting spray onto the front of the coolers/rad. You don't want to be soaking them such that water is dripping off, but a small most on/off so that the water evaporates. That point of it constantly evaporating, rather than being soaked in water, will pull a LOT of heat out of the cooler. I'm literally thinking just the little mist sprayers for a garden from Bunnings. Being in a low humidity climate it will help even more! The other trick if you want to be ghetto is some shade cloth hung in the opening, and keep it wet. Pretty much now it's acting like an evap cooler on a house, but cooling the air you need to use to cool the radiator...   On a topic to think about too though, when air enters through the bumper, is it all nicely ducted from the edges of that opening back at a nice angle, or is it like most cars, and the edge of the opening just stops, and suddenly it's wayyy wider behind that? If it does the later, get it shrouded out at nice angles. When that opening changes too rapidly, it can actually cause a high pressure zone between the front bar and radiator, and limit air flow into that area, which means less air for cooling, as it effectively stalls the air, AND adds to drag...
    • Do you have any before and after photos? That's $200 just for the hydro blasting?
    • It doesn't look like there's a lot of options out there these days, and what's out there is performance oriented aftermarket stuff (with the GTR markup) I wonder if there are other cars with similar springs, after all its just a matter of length, diameter and stiffness. Alternatively, I did see coil spacers. Probably not the best option, but could be serviceable too.  
×
×
  • Create New...