Bsa

Hey everyone up for sale I have Td06h-20g turbo 8cm housing only done dyno runs was on a rb20 $500 Custom intercooler has gtr tanks on a new core $100 Rb25det head port and polished $300 Sr20det black top head non vct $250 Sr20 block needs a hone $80 Apexi boost gauge $50 Turbosmart external wastegate 35mm $250 Rb20 bell housing $50 Rb20 STD cams $70 Contact me on 0449831518 for pics Will post some items others are to big and heavy

Cas is on the front of the engine exhaust side and o2 will be fitted to the dump

It works that way just have the pipe come down past the oil filler cap

You can get a Holden cat and run a 3 inch pipe through it then it looks like you have a cat on less attention

Na I don't my phone died while I was doing the job sorry

I worked on one the other week a vt wagon it was at a fab shop on the coast it was stroked and he is running twin turbo -9 turbos needed a few things done was near finished I did his intake pipes

Yes but 26 turbos are t25 not t28 and also have there own funky thing going on with flanges but you are right the dumps will fit a stand corrected on skyline dumps will fit only rb20/25 dumps are 6 bolt and won't fit

I'm guessing you want low to mid range torque then why not run a big single

What are they going on

This bringing back memories gtsboy haha let's not get into that again

Sr20 is my bet so silvia. Skyline t28 turbos are 6 bolt

How many bolt holes are in the housing where the dump connects

They should a sr20 dump should fit if they are 5 bolt or a skyline dump should if they are 6 bolt. If you want a t3 flange a rb turbo rear housing will fit depending on brand of turbo at they are t28

Could always do the extrnal gate mod

Good to hear mate you will remember this when you go to put a motor together again haha

Td06 I have one for sale that will reach needed power goals

Haha its a blank off plate the stock bov goes there as gtscott said get some vacume hose and put a bolt in it so it is blocked off or buy a stock bov

I recon you can't go wrong with the gtr plenum just costs a fair bit to mate to the rb25. Also the throttle body designs are much better then most aftermarket plenums it's almost impossible to get 100% flow equal to all cylinders. Iv done so much research on this stuff I'm currently making a plenum for a rb25 and the gtr plenum is one of the best designs going

Haha yeah

Yeah I'll come get it soon just have a few things going on now that are more important but will be soon

I'm sure if you asked kando he would just sell you the core then you can re use your housings.

Change the plugs just get normal plugs. The cas may be the most likly your problem I remember helping a mate fix a 33 skyline same problem the cas bracket was cracked was enough to put timing out at revs replaced that and it was fine. But yes a new set of coil packs won't hurt. Get your timing checked

Buy a kando for that much

My missteps always into me about working to much but money talks much louder then my chick haha

Get a z32 afm