Jump to content
SAU Community

Recommended Posts

:lol: no not the 1'c u get extruding from your anus!

When i give my car a hard run, i get that bad egg fart smell coming from the exhaust, and i was told it was the cat that was causing the smell! Its a highflow cat, any1 else got this problem??

Would the cat smell like that if its getting ***ed up?

Link to comment
https://www.sau.com.au/forums/topic/10664-that-egg-fart-smell/
Share on other sites

solution...unscrew cat.....enter fkn big hammer and steal"ram rod".....place ram rod in side cat....continue to strike ram rod with fkn big hammer until day light is seen through your meow meow.....take 1 peice of pipe and slide it inside cat and weld with mig welder...replace cat and no more smell...(oh btw this should be done on race cars only :D )

Originally posted by ylwgtr

solution...unscrew cat.....enter fkn big hammer and steal"ram rod".....place ram rod in side cat....continue to strike ram rod with fkn big hammer until day light is seen through your meow meow.....take 1 peice of pipe and slide it inside cat and weld with mig welder...replace cat and no more  smell...(oh btw this should be done on race cars only :D )

Or just put a pipe in through the cat.

that smell would b sulphur, sulpher reeks

DONT USE BP, use Optimax

i have no problems at all with optimax

my mate used to always use bp and his car pinged like a b***h! he took it to his mechanic and they drained it and threw it away, said that it is junk and to use optimax...

Originally posted by JET-33

that smell would b sulphur, sulpher reeks

DONT USE BP, use Optimax

i have no problems at all with optimax

hmmmmm

From what I have read, Optimax has the highest levels of sulphur, and BP has the lowest... so I would think that optimax is worse.....

But anyhow, dont worry about the smell Denham, it's nothing.... My womans Astra has been making that smell from new, so I wouldn't worry. I've noticed some cars make that smell while some dont, and all the ones that have had it were brand new.

Zahos

thanks for the replys!

I will try optimax next fill up and see what happens! I dont want to gut the cat as i already got a notice from the epa saying my car is 2 loud, so if i was caught without a cat i would be in serious strife!

Al

its not 2 much fuel at high rpm cause it runs a constant 12.1 a/f ratio cause of the safc!

I get a similar sort of smell but it's not the fuel.

I know where mine comes from...

it's a gearbox boot/seal that's a bit stuffed and after a few 7,000 + RPM changes the smell starts to get inside the car.

Just a bit and you can smell it outside also!

Maybe that's what it is ?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...