Jump to content
SAU Community

Recommended Posts

Mine sits around 4 in the morning for warm up. Once the oil gets to 80-90*C it will then drop down to around 2 i think. after a long day it will idle under the first bar (Not the zero bar obiously). I have been told that when its low after a long day, its ok because oil is all over your engine and doesnt need to be pumped at high pressure.

Other wise the guage is stuffed. =) See a mechanic to know when your oil pump is on its way.

bye

interesting post guys. My 32 GTR and one of my best mates with same car, have totally inconsistent readings.

I usually have 4 on warm cruise, but some times after idle ( at lights etc) it barely makes 2. I get a bit concerned and stare at it, then 10 seconds later its 4. ( irrelevant of revs )

Never the same each day.

We have come to the conclusion that the standard guages are a bit dodge.

The best way to put your mind at rest is to put in an aftermarket guage.

I have a Greddy one on the way, will tell u how it goes.

Dont sweat, it may just be the guage.

thanx for your input guys!

started up my car this morning and the oil pressure was up to bloody 6. then it drops back to around 3. Then during hot times in the afternoon after ive been driving it, it sits at just above 1. it got me worried coz someone was telling me basically my engine is stuffed and a rebuild is needed. but i dont see any smoke or nothing coming out of the zorst, also the engine runs really smoothly without any miss firing or undue noise. so i guess its all right then.

getting the car checked out next week, so ill know for sure. at the mean time, i was told 1 bar is the low end of ok zone, as long as the oil pressure light is not on. again, as someone said, it could be the sensor or gauge, or even bad oil.

any way, ill let u guys know. cheers!

thanx for your input guys!

started up my car this morning and the oil pressure was up to bloody 6. then it drops back to around 3. Then during hot times in the afternoon after ive been driving it, it sits at just above 1. it got me worried coz someone was telling me basically my engine is stuffed and a rebuild is needed. but i dont see any smoke or nothing coming out of the zorst, also the engine runs really smoothly without any miss firing or undue noise. so i guess its all right then.

getting the car checked out next week, so ill know for sure. at the mean time, i was told 1 bar is the low end of ok zone, as long as the oil pressure light is not on. again, as someone said, it could be the sensor or gauge, or even bad oil.

any way, ill let u guys know. cheers!

Before you rush off & start replacing anything do a search for oil pressure - there are about a bazillion posts on the subject.

A couple of things:

The oil pressure will always be higher on a cold engine thatn on a warm one because the oil has a higher viscosity when cold.

The oil pressure sender unit on the Nissans is known to be rubbish. It will send erratic pressure readings to the gauge. Hence before you get anything removed check the pressure sender unit either by substituting it with a known good one or by getting a mechanical gauge put on the car by your mechanic as a test.

The overwhelming probability is that the send unit is stuffed & the engine is fine. It will cost maybe a couple of hundred dollars if you want to replace the sender unit, but most people don't even bother doing so.

Edited by djr81

personally i would never go by a factory fittef oil pressure gauge, for one skylines always seem to have problems with them, just save a lil money mate an get a fairly good quility aftermarket oil pressure gauge. Depending on brand/ size, ur looking around 80- 140 bucks.

A lot of the Oil Pressure Gauges on GT-Rs are faulty. Mine sits on just under 3 most of the time but some days it sits under 2. Restart Car and it is back up to just under 3.

Also depends on the Oil you use. The Full Synthetic Oil will usually make the reading a bit lower.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sorry to hear your HFM BM57 was faulty,  did you contact HFM I would hope they would be at least grateful for the information if there was some sort of manufacturing fault, you would hope they would be sympathetic even if your item was 2 years old if it had never been fitted. May I ask where it leaked from ?
    • Cats are called Bella, and Donna...  Like that poisonous plant And I remember your 2 monsters, I remember making a little bit of wee when you let them out... LOL I have already installed cat doors into the laundry where their kitty litter is, and the sun room, apart from the cat doors there's not going to be any permanent mounted stuff on the interior walls (interior doors are cheap and easy to replace) I will get a outdoor cat cage thingie once I finish the landscaping out back... https://catnip.com.au/ The only off limit areas are the main bedroom and the gym room....but, currently the cats are curled up in bed, in the main bedroom with the Mrs.....LOL, the off limits for the kittens to the main bedroom lasted about 5 minutes with Jackie I currently only have 1 free standing huge cat tree multiple level scratching post thingie in the lounge room, but, I will be getting another one soon now that I'm happy with the furniture layout in the back room and have a perfect spot for it  
    • All of this is making it seem clear that running the Coppermix twin was definitely the way to go, especially in hindsight with how insane tariffs have gotten and the strength of the USD vs yen at the time.
    • That sounds like no chance of even importing one for road registering then Now I see why Duncan wants to check LHD rules for Targa...   I wonder how "bolt in" the AWD would be if you got one imported from the US and swapped it to an AUD one
    • Not to mention they drive like a bucket of bolts! yuck!
×
×
  • Create New...