Jump to content
SAU Community

Guess Who's Back? Back Again.

writeoff

By writeoff,
in South Australia

 Share

Recommended Posts

writeoff Mentor

writeoff

Posted
Posted

Yay for me. After a couple of months waiting for me to choose coilovers and save some $ (I get paid monthly) my GTR is finally back on the road with some new goodies. ;)

GReddy Type S coilovers

dba 4000 slotted rotors + Ferodo DS2500 pads

Tyre rotation

Wheel alignment

Dyno tune producing 248.5 rwkW at Boost Worx :)

Now I just have to wait for this double demerit point long weekend to be over and go for some hill runs. :)

Link to comment
https://www.sau.com.au/forums/topic/113463-guess-whos-back-back-again/
Share on other sites
Whiplash Grand Master

Whiplash

Posted
Posted (edited)

are you still selling it? was looking at it on carsales this arvo.

might see you up in the hills as i think i live up near you, have fun ;)

edit - sorry just noticed that you have two of them.

Edited by Whiplash
writeoff Mentor

writeoff

Posted
  • Author
Posted (edited)

I'm selling the white GTR.

This thread was refering to the grey one. My bad... I should have stated that.

I jump in the white GTR after using the Pug as a daily driver and think "F**k this is a great car"

Now I can jump in the grey one again and just start giggling. I love this car!

Edited by writeoff
writeoff Mentor

writeoff

Posted
  • Author
Posted
did u replace the rotors all round or only front are the 32 rotors able to me machined to fit a 33 in a 4 stud pattern ?? so many questions :P

I only replaced the front rotors but put new brake pads on both front and rear.

I don't know if the rotors can be machined to fit a 33 in a 4 stud pattern. The old rotors are gone. They were under 28mm thick and therefore not street legal.

writeoff Mentor

writeoff

Posted
  • Author
Posted

I've been around... on the forum at least. But I haven't been on a cruise since the grey GTR's front passenger coilover seized on the late night cruise we did to Gawler a few months ago. Since then it has lay dormant waiting for new coilovers (turned out the rear driver's side one had seized as well). I went to check point 3 (BP South Rd, St Marys) in the white GTR for the Victor cruise (which had the best turn out I've seen for a SAU event) but didn't go on the actual cruise. Now I can mingle with the 'lines again.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • LaurelPWR
      Forced Performance Hta Turbos

      By LaurelPWR · Posted

      Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • Shizu
      Sheraaz's R34GTT Build

      By Shizu · Posted

      Thanks mate.
    • TurboTapin
      Crank Motorsports Front Axles

      By TurboTapin · Posted

      I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Shizu
      Sheraaz's R34GTT Build

      By Shizu · Posted

      Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Shizu
      Sheraaz's R34GTT Build

      By Shizu · Posted

      Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...