Jump to content
SAU Community

Recommended Posts

Greddy Timer, Position behind the centre console (can't see it from the front).

i.e. Wires straight from the back of the steering wheel -> behind console, seems stock. If ever need to get it hand just goes down and its right there :)

Ashtray is good -> many people i know in 32's have it positioned there and certain authorities haveny been able to find it ;)

  • 2 weeks later...
Blitz Dual stage... sits above my left kneee cap.

dont cops see that? I have a Pivot digital speedo on my dash and first thing cops ask me "is that a turbo timer?"

I have a HKS turbo timer and its behind the carpet in the footwell

Underneath the steering wheel, behind the plastic facia - well out of sight (impossible to be seen); oh, and SWITCHED OFF - switched it off upon delivery of the car, didnt even know it had one until I went to fill up and the car continually ran while I was putting in petrol (just a tad dangerous me thinks).

WTF do ppl need a turbo timer for? Wank factor I reckon.

Tangles,

A turbo gets extreemley hot. Sometimes even glowing red.

Metal when it is hot should be cooled down gradually (on idle) not rapidley (turning car straight off).

Metal stretches and expands some what with heat and cooling it down to quick will make metal brittle, or crack, or worp.

Thats why my timer for example (apexi) is attached to the oxygen sensor. The more air that flows through it (eg. if your putting your foot down) the longer the automatic feature on the timer will keep the car on. I just set mine for a minimum of 30 sec and a max of 3 min, and the timer figures out how hard I have driven the car and sets accordingly.

Hope that helps

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • A lot of the trim pieces on the E39 are super brittle and just dissolve when you try to get them off. It looks like a previous owner has used what can only be described as an industrial construction foam adhesive to glue down a tiny piece of trim.  Unfortunately this part of the tailgate is starting to rust because of how much shit is in here. This is stopping the water draining and there's a big build-up of dirt that is just staying wet. How can I remove this? Would a flap disc get rid of this?  I think this car spent a lot of time inland. There's so much light coloured, fine dirt and dust everywhere.  Sorry for the pic. I've cleaned this all up now so I'll get another pic of it clean today.
    • Surely, just about any shop that has done a Skyline (or Supra, or RX-7, or EVO, or WRX) will have done E85. But perhaps you need to specify what type of car, what type of engine, what ECU, you propose to be using.
    • Try an oil additive. There's a couple of options for "easier shifting". These are essentially a similar idea to what Redline put into their Shockproof gear oils. I had a 2nd hand R33 (in fact, as of right now, it is still in the car) that simply would not engage any gear with the engine running, with normal gear oil in it. We dropped that and replaced it with Shockproof lightweight, and suddenly the gear lever did what it was supposed to. At a cost, of course, of the then ongoing damage to internals done by running Shockproof. But the synchros were already totally uninterested in life, so there was no loss.
    • It always ends with the car burning down.
    • I see what you posted, but how could a warning light be going on and off if there is no sender for it?  The only other explanation is that the wire that used to go to the sender from the warning light is earthing somehow in the loom or at the connector, or that you have connected the warning light wire to something (maybe the temp sender?).  
  • Create New...