Jump to content
SAU Community

Recommended Posts

Hey guys i just bought a R32 GTST and interms of engine mods it has a 3inch turbo back exhaust, a Cold Air Intake, a 500hp Boch fuel pump and a BOV. These mods were already on the car so i was wondering what the nxt step would be interms of reachin 180rwkw...... :angry:

could anyone tell me what coil packs do and if they would give ma a bit of power and yeh what the nxt steps i shoudl be takin were...oh and by the way im not prepared ot buy a bigger turbo or a another ecu atm so yeh jus pov mods at the moment lol :D

thanks

Daniel

Link to comment
https://www.sau.com.au/forums/topic/114929-r32/
Share on other sites

hi mate congrats on the purchase, all i can think of is a front mount and a boost control i'm in the same boat not prepared on getting a bigger turbo just yet, my line is pretty much same as your as mods go apart from fuel pump, not so sure bout the coil packs i'd ho;d back on them until you upgrade your turbo, i'm planning on getting a adjustable fuel pressure regulater and a bosch 044 fuel pump soon and i think that will do me for awhile until i saved enough for bigger turbo,

Link to comment
https://www.sau.com.au/forums/topic/114929-r32/#findComment-2116177
Share on other sites

you sure your gonna require a 044?

thats pretty big, and damn noisy, oh and external aswell.

have a run through here

http://www.skylinesaustralia.com/forums/in...howtopic=103095

see what they have and how much power they got.

Link to comment
https://www.sau.com.au/forums/topic/114929-r32/#findComment-2116179
Share on other sites

congrats on teh purchase!

- firstly give it a service: oil, oil filter, coolant, spark plugs, fuel filter, oxygen sensor

- then, put it on the dyno for an hour and get the tuner to see how healthy the engine is. they can also play around with your timing to get the most out of what you have got. plus you will get a power figure to see what the car is making

What are coil packs you ask?

they are coils within a little plastic pack that sit over the spark plugs. there's one over each spark plug. they generate a signal when instructed to do so, and pass this to the spark plug which creates a spark to ignite the fuel.

Will putting bigger coils generate more power?

Well it will generate a bigger spark, but this probably won't equate into much more power unfortunately

if you want to play around with the car a little more, i would suggest thinging of some of the following:

- front-mount intercooler ($300) and piping ($400)

- boost controller ($50) set to about 12psi (any more then 14psi can cause the turbo to fail)

That will give you a nice jump in power. they generally say 1psi raises power by 10kw when in the right setting (ie already have exhaust and intercooler)

good luck!

Warren.

Link to comment
https://www.sau.com.au/forums/topic/114929-r32/#findComment-2116202
Share on other sites

Will putting bigger coils generate more power?

Well it will generate a bigger spark, but this probably won't equate into much more power unfortunately

will only give a power increase if the current coils are not working.

Link to comment
https://www.sau.com.au/forums/topic/114929-r32/#findComment-2116258
Share on other sites

Next step is a fmic, and unfortuately thats the end of the pov mods. Turbo, injectors and ecu are next.

You will need a turbo to make 180 as the stocker doesn't like to play much past 160 odd. An rb25 turbo will do it though and they are cheap enough.

Link to comment
https://www.sau.com.au/forums/topic/114929-r32/#findComment-2116555
Share on other sites

fmic and 14psi boost should see close to 165-170rwkw if you are willing to test that sort of boost on stock turbo..

a few people have..

i think both roy and cubes ran this sort of boost on stock turbo and it didn't break..

no guarantees though..

180rwkw is not going to happen with stock turbo.

fmic kit from JUST JAP will set you back $500 or so.. see traders for sale section.

Dr Drift can also do retuned Stock ECU for about $400 or so I think.

now.. you say you don't want to change turbo but considering an Rb25 turbo will cost you like $350 these days, it's cheaper than both the above bits, but they are ALL needed for the 180rwkw you are after.

Link to comment
https://www.sau.com.au/forums/topic/114929-r32/#findComment-2116586
Share on other sites

thanks heaps...i do have a boost controller (sorry forgot to mention) i boosted to abotu 15psi and started to shyt myself abit so i turned it down to about 10 lol so i decided to do what u guys said and look at a 33 turbo and yeh its onlly about 300 bux anyone know about how mani kws u can get out of it and how much boost it can handle ?

And as for the front mount ive been looking and alot of them, theres heaps of copy ones out there and they all claim to do the same as the hybrid ones but like yeh not too sure about that ;) Im thinkin i should just hold out for a lil while, not settle of crap, go for quality and buy the Hybrid 600mm yeh ?

cheers

oh and i knwo this isnt the place to post it but im afta a new steerin wheel so if ne1 got one and lives in melb let me know...cheers ( again sorry about postin this in here)

Link to comment
https://www.sau.com.au/forums/topic/114929-r32/#findComment-2117990
Share on other sites

hybrid copies are fine.

they are all the same except that HYBRID have plastered their name on the core.. it's the same core as the non marked ones, and comes from the same factory.

it'll do the job and do it well.

r33 turbo will make around 170-190 rwkw on about 13-14psi on an RB20 depending on dyno.

Link to comment
https://www.sau.com.au/forums/topic/114929-r32/#findComment-2118076
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
    • I know I have to get a wheel alignment but until then I just need to bring the rear tyres in a bit they're wearing to the belt on the inside and brand new on the outside edge. I did shorten the arms a bit but got it wrong now after a few klms the Slip and VDC lights come on. I'd just like to get it to a point where I can drive for another week or two before getting an alignment. I've had to pay a lot of other stuff recently so doing it myself is my only option 
    • You just need a wheel alignment after, so just set them to the same as current and drive to the shop. As there are 2 upper links it may also be worth adding adjustable upper front links at the same time; these reduce bump steer when you move the camber (note that setting those correctly takes a lot longer as you have to recheck the camber at each length of the toe arm, through a range of movement, so you could just ignore that unless the handling becomes unpredictable)
    • I got adjustable after market rear camber arm to replace the stock one's because got sick of having to buy new rear tyres every few months. Can anyone please let me know what the best adjustment length would be. I don't have the old ones anymore to get measurements. I'm guessing the stock measurement minus a few mm would do it. Please any help on replacing them would be fantastic I've watched the YouTube clips but no-one talks about how long to set the camber arm to.
    • Heh. I copied the link to the video direct, instead of the thread I mentioned. But the video is the main value content anyway. Otherwise, yes, in Europe, surely you'd be expected to buy local. Being whichever flavour of Michelin, Continental or Pirelli suits your usage model.
×
×
  • Create New...