Jump to content
SAU Community

Recommended Posts

No worries... Happy too... :thumbsup:

As for the PWR we had her up just over 300rwkw then we turned her back down to 270rwkw to make it drivable...

what turbo are you running? What rpm does it come on? What boost? I had 320kw at 15psi but the fconv couldnt be tuned so i only ever really ran 12psi on the street which was enough, afr's were way to rich though and i continually fouled plugs....I miss driving/being in high hp cars :teehee:

Down the quarter mile yeah...

Ill take that bet... I get to run slicks on the rear and you get to run street tyres...

ur on :thumbsup:

oh and while we're at it, wanna put money on it too?

i'll be running street tyres, slicks are for girls :teehee:

Short story;

GT 30 0.82 rear

Ran 16psi to make 267rwkw @6200rpm

Ran 19psi to make 301rwkw @6200rpm

Boost came on hard at about 4300rpm...

Turbo is capable of 24psi so estimate about 400rwkw is its limit on a dyno dynamics dyno... But my motor is not going to handle anythign more that 16psi at a track day... So thats where it stays and then for dyno days we will run 19psi...

ur on :thumbsup:

oh and while we're at it, wanna put money on it too?

i'll be running street tyres, slicks are for girls :teehee:

Whats your estimate on my times down the quarter???

Considering I spent over 4 grand just on the rear rack, suspension and diff... So its setup for drag...???

Short story;

GT 30 0.82 rear

Ran 16psi to make 267rwkw

Ran 19psi to make 301rwkw

Turbo is capable of 24psi so estimate about 400rwkw is its limit on a dyno dynamics dyno... But my motor is not going to handle anythign more that 16psi at a track day... So thats where it stays and then for dyno days we will run 19psi...

u do realise a forged motor will only set u back about 5k?

Whats your estimate on my times down the quarter???

Considering I spent over 4 grand just on the rear rack, suspension and diff... So its setup for drag...???

mid 11's

hey shane.. uh its little american but not strong..

im born in hawaii.. so im from all over the world.. ahaha

lol thats pretty funny

is this shane vs col??? Id put money on that..but i wanna see how both of you drive first, have either of you been to the strip before? What are your 60fts?

1.8 60' with 265x17x40 hankook k104 with a R33 gtst and 191rwkw :thumbsup:

full specs of both cars...is your car going to be set up for drag shane?

mine's too big to list, and i've listed it b4, however i'll go copy and paste it...and no, it's being set-up for circuit/hill climbs :teehee:

oh and i've done about 25 passes with my old car :thumbsup:

5k how did u spend 13.5 and not get it idling yet?

go all out lol

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • For fuelling the Haltechs have O2WB fuel controllers. Very useful for helping tuning VE and correcting for *small* mistakes. Of course if your injector/cam/trigger/sensor data is just wrong (or for a GTT which is not a GT) then you will get impossible reactions to things. I am sure you know this already but the reason people don't typically put haltechs (or any Aftermarket ECU) on GT's is because there's practically no real gains to be had - So this knowledge won't be commonplace.
    • Can someone tell me if the cracks seen in the rear sway bar bushings in these photo's is unacceptable from a roadworthy point of view?  
    • Shouldn't need a "base map" for anything other than guidance to ignition tuning. You just need the engine capacity right, the injector size right, and something, almost anything, for a VE map. On an NA engine, fuelling is almost completely a function of load signal & rpm. It should run and drive with a completely flat fuel map. It will be too lean under load, but that's easily fixed. We used to tune all ECUs without any base map. There were no such things (until someone had tuned a near stock engine on one, and then they had a "base map".
    • What did you actually buy/how much did it cost? When I got mine in like.. 2017...? 2019? the aim was to run Torque for gauges via ODB2 and things like Track Addict/Laptimers/Dashcam/Reversecam/Spotify etc. Mine never broke, but I wonder if you've got the same needs (it sounds like it). Cause I liked the idea of being able to do anything with it. That said, yours also cost 3x the cost of what I spent so... food for thought.  
    • For me there is a massive difference in manufacturer or big brand crippled android (Sony, Kenwood etc) vs the sort of thing I've installed here, which is basically just a tablet in DIN form factor with open Android, and the other model of course is mirroring - Android Auto/Carplay. I hate the locked down manufacturer and AA options where they decide what apps I'm allowed to install, including the Launcher but also importantly things like Ecutek (for this car) or Real Dash (Stagea) are not supported. Plus those crippled versions tend to be slower due to both overheads and lower spec hardware. On the other hand, when this breaks I'll likely be in trouble for support....but how is that different to owning an Infiniti anyway
×
×
  • Create New...