Jump to content
SAU Community

Recommended Posts

Nick I hate you. I want... No need more money

Don't we all. I want my online banking to take 2 minutes to load cos I break the Internet with my huuuuge bank balance!

Then I want my shelves to start buckling under the weight of my copious shoe collection and the age old question of where to store my huge collection of Skylines.

Affirmitive action. Females are required to be paid more in trades based roles. Govt plan to get moar wimminz out of the kitchen.

Why have I been doing Nursing all this time? Should have became a Lady Tradie.

Same with Nursing. Men are paid like an extra 5-10% based on qualifaction and govt hospitals have to hire x male graduates to xx female graduates because of their commitments to workplace diversity

No they don't. The government pay the company and the money just goes to the company, not the females.

Women are meant to be paid more. Meant to... The government was supposed to offer subsidies to employers who did, but doesn't look like it's actually come about. Another empty promise?

I think that has come about Tony, and we are seeing more women present in the workforce than ever before. The is issue comes down to not having adequate laws to reinforce and support equality in the workforce.

How is it equality if people are being paid a different amount just because of their gender?

its an issue that will never really be resolved, if everybody got along there would not be as many problems in the workforce or anywhere else as a matter of fact. Its unfortunately in our human nature to make things complicated and difficult.

I for one am all for equality, in fact I was under a female manager for a several years of which I have the utmost respect for.

However, there is always friction between each sex, especially in the workforce.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So, this shouldn't be such a mission, but there were a few tricks so I thought I'd post up a DIY for it. This was on a Q50 Red Sport but I doubt any other V37 model is very different (maybe just less steps for the intake heat exchanger hoses) I pulled the radiator out to flush it because the car was running hot at the track, but obviously the same steps apply for changing a radiator for any reason including an upgrade. If you are removing the radiator, you of course need to drain and refill, so have 5+ litres of blue coolant ready. You don't need to drain the intake heat exchanger to remove the radiator but depending on your plans you may need a couple of litres for that as well. You will also need something to deal with the auto transmission lines, I used 2x 8mm rubber caps on the radiator side, and a short length of 8mm pipe on the car side.....unless you can block these lines quickly you will loose AT fluid and it may be enough to hurt the transmission if you don't refill it. Other than that....lets go... "First, jack up your car". Yes really, and put it safely on stands. If you are not confident doing that you need to give this job to a mechanic
    • If the forester is anything like our old 2007 GTB Liberty, I could near on run ling Long's and "rate them", as no matter what, it just hung to the road, even when abusing it in a hard launch in the wet, or throwing it at corners.
    • LOL, all of the CAI like Craig I just need to put a hole saw through my bumper Done and dusted, the car runs, which is nice, I'll take it for a spin when the weather clears up Just need to put the bumper back on for good
    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
×
×
  • Create New...