Jump to content
SAU Community

Recommended Posts

Rematch?

Maybe it doesn't count posts in member only sections?

it does.

but only to the person who can see it.

eg, I had alooot of posts in nsw last night, you couldnt go into that section, so couldnt see the post count including those posts.

it does.

but only to the person who can see it.

eg, I had alooot of posts in nsw last night, you couldnt go into that section, so couldnt see the post count including those posts.

Yup. Thought so. That's why when I post in the exec section, you can't see my post count going up.

I don't think they will win. They can't seem to get their shot together.

The last test and this test so far their shit is very much together. Bowling had been spot on and they scored more than 700 runs last test. This is like 2005, or team is starting to come of age while England is getting old, summer over here should be fun.

The last test and this test so far their shit is very much together. Bowling had been spot on and they scored more than 700 runs last test. This is like 2005, or team is starting to come of age while England is getting old, summer over here should be fun.

Going to the text up here? McFly and I were discussing it.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
×
×
  • Create New...