Jump to content
SAU Community

Recommended Posts

my battery keeps going flat... I had a bit of a search bout alternators and what not and did some tests with the ol multimeter... im just not sure wat the results mean :laugh: Also i had the battery replaced about a yr ago.. for one of those racv ones... but evan with the new one it would go flat if u just sat in the car for like 30-45 mins...

anyways so i jumpstarted the car to get her going just now.. and hooked up the multimeter to alternator.. it sat on a constant 14.5v.

Then i slapped it on the battery in the boot and that was also showing 14.5 or so (as was the pfc hand controller)

so yeah... what does that mean ;) ??

thanks ppls ;)

Link to comment
https://www.sau.com.au/forums/topic/121380-battery-alternator-blah-blah-blah/
Share on other sites

the battery that you got might have been sitting there for a while before you bought it. cold weather is the true test of how good a battery is. if the alternator is cactus then the battery would lose power as you drive from using the brake lights, indicators etc. i'd go and buy a century battery. that way you have the 3 year warranty or however long it is.

When you test the voltage output of the alternator, you are presumably testing at idle. Try raising revs to, say , 2000 and measure output.

It should remain the same voltage (ie around 14V). If it increases, then the alternator is kaput - it is overcharging the battery, and overcharged batteries don't hold charge.

I always thought that if you raised the revs and the voltage didn't increase then your alternator is gone.

ie. If you start the car and it stays at 12, and if you rev the car and it stays at 12, then the alternator isn't working at all.

cool thanks guys ill give her a rev and try it 2nite again :P

but ya still abit confused.... if i rev is it meant to stay the same or go up... ?

As blind_elk said, when you rev it should stay the same.

If it goes up then it's overcharging your battery, which is bad.

ok well im gonna buy another battery..

just out of curiosity tho.. cause i dont understand the hole battery/alternator thing... atm my battery is at 11.x volts and it wont start... but somebody else was telling me there battery is also 11.x volts when the engine isnt running... so like.. why the hell wont my start if its the same as other ppls :dry: ???

I woulda thought if the battery was flat it'd be below 11.. or woteva the normal voltage is when the cars not running.. ??

Justin,

a fully charged battery should show 13.2 volts, engine not running and no load(6 cells times 2.2volts per cell)

truth is you will rarely see that. Start your car, and at the battery you are looking for @ 13.8 - 14.5 volts at approx 2000rpm, if it reaches 15 volts or higher it is being overcharged, less than 13.0 volts poss crook alternator or possibly voltage drop between the alternator and battery(bad wiring). Take your car to an Auto Electrician and ask them to load test your battery.

The other possibility is that something is draining your battery when the car and all accesories are tuned off, eg boot light staying on, glovebox light staying on, relay drawing power etc.

Dont just go and by a battery add hoc, it may be a waste of money.

Topper

anyone know what the settings are on multimeters to check the AMPs drain on a battery while the cars are off..

trying to remember but cant, also the points on the battery and earth to check this would be helpful too.

Don't buy anything until you are certain what the problem is. There are a various tests you can do to see if the alternator is failing or not. Just do a few google searches. You're mainly interested in the impedence/resistance between a few particular points.

Also: The battery will show whatever voltage what battery is supposed to output unless you put a load on it. A multimeter won't do much in determining that, unless it has a dummy load also.

anyone know what the settings are on multimeters to check the AMPs drain on a battery while the cars are off..

trying to remember but cant, also the points on the battery and earth to check this would be helpful too.

Set the multimeter to amps dc, start at around a 10 amp range, disconnect the neg battery terminal and put one lead of meter to neg batt terminal and the other to the battery lead(the one you disconnected). With doors closed everything off you should have less than .2 of an amp drain. DO NOT try and start the vehicle or turn on any high load items whilst doing this test.

well i noticed my racv battery had a 2 yr warranty.. so i got em to come round and replace it for free :) they did some tests and rekon its def the battery... (allthough when my engine blew up they rekon it was just out of petrol :P)

anyways ive got another concern though. How much cranking power thingy (or woteva its called) should a battery for a skyline have ??

I noticed mine is only 370 which doesnt realy sound like a lot.. ??

I dont have have a big audio setup or anything though... pretty much just the head unit.

thanks again for all the help :D

370 should be ok. Little on the low side. I think the one I replaced was 270cca..so I think you have bigger than the stock one..

If youre not runing a big system I reckon it should be ok for a couple of years or so. Just dont leave your lights on or parkers for too long with the engine off.

Set the multimeter to amps dc, start at around a 10 amp range, disconnect the neg battery terminal and put one lead of meter to neg batt terminal and the other to the battery lead(the one you disconnected). With doors closed everything off you should have less than .2 of an amp drain. DO NOT try and start the vehicle or turn on any high load items whilst doing this test.

cheers for that,

exactly what i was after :(

mine will be a huge drain though :)

550cca battery and too low to crank the engine after 2 days

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
    • Thank you so much for the help
    • Yes it is ATF. I quote @Duncan "it takes a good synthentic auto trans fluid like Castrol Transmax Z" It's not a diff. It's a transfer case. Totally different thing. Yes, fluid will come out the sender hole. No you do not really need to drain it. Just pull the old, quickly poke the new, clean up and top up. But realistically, you should probably take the opportunity to change it anyway.
×
×
  • Create New...