Jump to content
SAU Community

Recommended Posts

gday people im in need of some advice.....

ive got a 400kw at the wheels rb26 and am i need

of a new clutch... its got an osgiken twin plate in

it now thats starting to show some slip...... can you

adjust the clutch? or should i bite the bullet and get

a new unit for the beast?? can anyone recomend a

good clutch? should i get another os twin?

apparently the engine figures are 680hp/1080nm :wave:

Edited by rb27tt
Link to comment
https://www.sau.com.au/forums/topic/126480-i-need-a-new-clutch/
Share on other sites

hmmmm. At @ $2151 if i was getting a new clutch i would definatley get one, but i already have a twin plate i can just replace plates. Ah well, i'll wait till this clutch dies before i make my desicion.

sounds like a decent deal.. are they better than the os giken ones? i want a clutch that will cope a flogging!!! :) all i gota do i sell my ca18det datsun 1200 now to get some more funds........

y buy 2nd hand when u can buuy new... a clutch is something i would never buy 2nd hand... sould have fractures or something in it and you wouldnt know till it broke up........ dose anyone know how the nismo rates up against the os giken or hks or even exedy do multi plate now are they any good?

the new nismo coppermix twin plate clutches are much more streetable than the OS Giken twins and tripples. I'm yet to witness how well the hold up on track, but they definately look to be the goods for street driving.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah. You need 2x taps for anything that you cannot pass the tap all the way through. And even then, there's a point in response to the above which I will come back to. The 2x taps are 1x tapered for starting, and 1x plug tap for working to the bottom of blind holes. That block's port is effectively a blind hole from the perspective of the tap. The tapered tap/tapered thread response. You don't ever leave a female hole tapered. They are supposed to be parallel, hence the wide section of a tapered tap being parallel, the existince of plug taps, etc. The male is tapered so that it will eventually get too fat for the female thread, and yes, there is some risk if the tapped length of the female hole doesn't offer enough threads, that it will not lock up very nicely. But you can always buzz off the extra length on the male thread, and the tape is very good at adding bulk to the joint.
    • Nice....looking forward to that update
    • Neg, the top one is actually for the front. The sizes are 18x10.5 +18 and 18x11 +32.   I measured many times but I'm sure I'll have problems as this is the thread for problems.
    • Just one thing; tapping tapered threads is tricky. Taps are always tapered and you would generally run it as far as you can, but with a tapered thread you have to stop much sooner otherwise the wide part of the taper will run in too far and you will have to thread the sensor in too far too as well (possible that it will never make a good seal) BTW nice wide wheels, I guess the top one is for the back!
    • Welp, good to know. Will have to wait awhile until steady hands with drills and taps are available. In other news, these just arrived! I will weigh them for posterity. Edit: 11kg each (or 10.9/11.1 depending on what my scale decides over multiple tests, the 18x11 don't seem to weigh noticeably any more than 10.5)  
×
×
  • Create New...