Jump to content
SAU Community

Power And 1/4 Mile Times

GODTHRILA

By GODTHRILA,
in Western Australia

 Share

Recommended Posts

GODTHRILA Experienced

GODTHRILA

Posted
Posted

hey all, just about to get my R32 GTR on the road and was wondering if anyone would have a good idea of what pwr and 1/4 mile she should post?

Its jst had a engine rebuild, ACL forgd slugs, port n' polished head, hks cams, twin blitz pods, 3" xorst, nismo clutch, lightend flywheel, short shifter, std everything else. Boost is set to 12psi.

Link to comment
https://www.sau.com.au/forums/topic/129891-power-and-14-mile-times/
Share on other sites
play r 32 Proficient

play r 32

Posted
Posted (edited)

hmm pretty hard to guess but probably gonna be somewhere between 340 and 380 rwhp? Im no expert though.

As far as 1/4 mile time, my old man had a GTR with 396rwhp and he did a 12.3 the first time he took it down. A few people in the know said it should run better times than that with an experienced driver.

Edited by play r 32
GODTHRILA Experienced

GODTHRILA

Posted
  • Author
Posted

thanks for the info guys. Can't wait to run the new motor in and then she what its capable of with a good launch. Some better breathing turbo's would be nice but the wallet (and wife...same thing i guess) at the moment say no! When the time comes I think i can hear a pair of HKS GTSS's calling me. The next mods I think will be a pair of RB25 AFM and a Apexi powerFC.

The car should be on a truck by the end of the week, just bought it from the east coast... it torture waiting!!!

PSI_GTSII Experienced

PSI_GTSII

Posted
Posted (edited)
Hi Flite,

I c u have a 32GTR as well, wot hav u dun to it?

I have 32 GTR..?

Mine is 'totally' standard except:

GT2560R Turbos's

Greddy/ Trust Dumps and Front Pipe

Jasma 3" Exhaust

It has no boost control but has had restrictor removed, so boosts to just on 14psi, it was dynoed at Hyperdrive and produced 315rwHP @14psi

I ran it at the Motorplex and it ran a 12.6 @ 113mph (182kmh), this was with a very easy start as this is all the clutch would handle without slipping (Hence 2.1 60fts)

FWIW, I went and watched a SAU Drag night about 6months ago there were about 4 R32GTRs racing that night all of them ran around the 13.5 mark at 160kmh...so go figure :P:rofl:

Edited by PSI_GTSII

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • The Bogan
      NC MX5

      By The Bogan · Posted

      After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • joshuaho96
      R34 25GT Engine Light 21

      By joshuaho96 · Posted

      Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • joshuaho96
      R32 GTS (RB20DE) Injectors Replacement

      By joshuaho96 · Posted

      I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • GTSBoy
      R32 GTS (RB20DE) Injectors Replacement

      By GTSBoy · Posted

      No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • codygrimm27
      Can you mount the ATTESA pump in other locations?

      By codygrimm27 · Posted

      Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
×
×
  • Create New...