Jump to content
SAU Community

Recommended Posts

Sounds more like that it is spinning when it shouldn't. This is because it's a viscous clutch fan, and when it fails, it locks up.

If you start the car when it is dead cold, it should spin up and then come off after a minute.

Or, to test whether it has seized or not, tomorrow morning, open the hood, and try to spin the fan with your hand (car off!). If it resists a LOT, then it's seized and you need to buy a new one. Changing it is pretty easy though (4 bolts), and if you wiggle it, just a little bit, (hehe) it should slide past the radiator shroud.

Sounds more like that it is spinning when it shouldn't. This is because it's a viscous clutch fan, and when it fails, it locks up.

If you start the car when it is dead cold, it should spin up and then come off after a minute.

Or, to test whether it has seized or not, tomorrow morning, open the hood, and try to spin the fan with your hand (car off!). If it resists a LOT, then it's seized and you need to buy a new one. Changing it is pretty easy though (4 bolts), and if you wiggle it, just a little bit, (hehe) it should slide past the radiator shroud.

can it still eb driven until my new fan arrives? and where to get a new one? how much?

Edited by Suspense

You can drive it as much as you like. It will make a lot of noise from the air being pushed, and it will still cool everything (even when it DOESN'T need it).

New fan I think is under $200... Call Nissan?

the clutch on it has FAILED dude. this means what it does next is anybody's guess. which means it may loosen at any moment and start free spinning, i.e. not cool your motor.

if you're going to spend $200 on a clutch fan, why not upgrade to an electric thermofan for a bit more. i'll be doing that mod soon.

Don't panic....... Pull the fan & clutch off, if you're in Sydney, go see the boys at Just Jap in Kirrawee or SSS in Giraween ( or the like ) and grab a good condition second hand clutch off them !! Just make sure it bolts up to YOUR fan and looks the same ( but better than yours ) and away you go !!!

I was a bit suss on my clutch ( fan ) and scored an almost new clutch off an R34 RB25NEO that fit perfectly in my R32 RB20DET fan and works great !!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I like they don't raise their hands into the air when they shift their sequential boxes, seems to be a thing here in Australia lol...
    • I'm not normally one for posting random videos, but I thought we'd all appreciate the honesty about how broken our cars tend to be lol. Genuine skyline life here.   
    • New CAS just turned up from NZ Wiring. Looks like a nice bit of gear.  So, yeah. Triggered, bro. Realised I may as well do the cam belt while mucking about with it so will order one of them.
    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
×
×
  • Create New...