Jump to content
SAU Community

Recommended Posts

After a decent set of front pads for my car for street / occasional track use.

Last set were bendix ultimates and i wasn't really happy with them as they put out heaps of dust and didn't really have much bite. Some have said ferodo or endless pads are ok? Where can i get them and how much have you paid?

Link to comment
https://www.sau.com.au/forums/topic/136366-brakepads/
Share on other sites

yeah, they're an alright pad.... you can use them on the street (i run them) but they're better suited to the track/spirited driving (i.e. mountain runs etc) as they take a while to get some heat into them.

I used to run Racebrakes RB74's on the front / bendix ultimate on the rear previously - not a bad combo.

now i run DS2500's front and the same bendix ultimates on the rear... lol... they don't seem to wear out :|

just don't make the same mistake that i did and get the same pads front and rear... doesn't work :S

Link to comment
https://www.sau.com.au/forums/topic/136366-brakepads/#findComment-2535515
Share on other sites

I've actually got lucas pads in, Im suprised at how good they go. Bit of dust but not too bad. WAY better than the rb74s dust wise, and they arent eating my disks as much.

Dont know about track tho, but havent had fade on the street, and sometimes I give them a bit of a go just to make sure everything is still working.

Dont know exactly the type tho, they would have been about $100-110 a pair.

Link to comment
https://www.sau.com.au/forums/topic/136366-brakepads/#findComment-2537880
Share on other sites

Green EBC racing pads

I found these to be quite expensive for the performance they provided...

I will not use these again personally as they dont offer very good value for money...

bendix ultimates,

Had these on at the last track day and after 5 laps i had no brakes left...

Try Ferodo DS2500 for street/track.

I have just ordered a set of DBA slotted rotors for all four corners and i have purchased a set of these to go with the slotted rotors...

The bloke who set up our brakes for targa tas swears by them for street/track use and id have to say they were impressive in our targa car...

Link to comment
https://www.sau.com.au/forums/topic/136366-brakepads/#findComment-2538415
Share on other sites

Yeah, I won't touch EBC Green stuff again. Apparently I got a bad batch but the ones they returned to me were exactly the same and disintegrated within a month after screaming their tits off at the lightest touch of the pedal!!

I am running Ultimates at the moment and they are very dusty and I don't think they are anything special. Might have to invest in a set of Ferodo's before track day!!

Link to comment
https://www.sau.com.au/forums/topic/136366-brakepads/#findComment-2538576
Share on other sites

hmmm after seeing greenstuff used on a mates 180sx i recommended them to a mate with a sss pulsar.... great on the 180, havent got feedback from the sss... I know theyve been on the 180 for ages, with a set of bda slotted's. do an awesome job, we fitted them ourselves with a VERY noticable difference with minimal brake-fade after a lap or few of lakeside, so yeah. a "bad batch" really shows the quality and consistancy of a brand though, i guess. if someone relies on a brand then all of a sudden they get a "bad batch" and they are f***ed.... not cool. but to my own experience, fantastic... havent PERSONALLY come across an issue.

Link to comment
https://www.sau.com.au/forums/topic/136366-brakepads/#findComment-2538589
Share on other sites

I used DBA 4000 rotors front & rear, Ferodo DS2500 front and RB74 rear with MOTUL 600deg fluid on the 33 and they could lock the tyres easy as. Only problem was the were VERY squeeky on the street when they were cold & the dust from the ferodo's had me washin the wheels after every spirited drive. otherwise great set-up

Link to comment
https://www.sau.com.au/forums/topic/136366-brakepads/#findComment-2542550
Share on other sites

I used DBA 4000 rotors front & rear, Ferodo DS2500 front and RB74 rear with MOTUL 600deg fluid on the 33 and they could lock the tyres easy as. Only problem was the were VERY squeeky on the street when they were cold & the dust from the ferodo's had me washin the wheels after every spirited drive. otherwise great set-up

No offence Shane (as much as its not a bad set up) locking the wheels means one of 2 things. You hit the brakes too hard, or you have crap tyres (or both so I guess that is 3...)

Link to comment
https://www.sau.com.au/forums/topic/136366-brakepads/#findComment-2542619
Share on other sites

I have used Endless EuroX (the closest thing these days would be CC-X) and they were great but needed to get heat into them to work really well. Stood up to 5 laps of QR brilliantly.

Bendix Heavy Dutys were crap, and dusty.

A friend who does lots of hillclimbs and has held the record at Mt Cotton reckons the Ferodo 2500s are good.

I'm using QFM pads at the moment. For the price (1/3 of the Endless prices I was looking at) they're good.

http://www.skylinesaustralia.com/forums/in...howtopic=136212

Got them through John at GMR Fairfield (3844 2855).

Link to comment
https://www.sau.com.au/forums/topic/136366-brakepads/#findComment-2558289
Share on other sites

I'm getting Hawk HP Plus next, I went in a car with these and it hurt my face everytime the brake pedal was planted :D

Hahaha, But you must admit it was a definite improment to your facial features.

On a serious note, Hawk HP Plus are an excellent brake pad for high performance street cars that also make it to the track.( Not that my car would be classed as high performance by any stretch of the imagination) Hawks have a high temperature coefficient and zero brake fade after 2 sets of the National circuit at QR (in succession). They work extremely well from cold, and give fantastic feedback through the pedal. I use them with Motul RBF 600 FACTORY LINE fluid.

The only downside would have to be the very slight squeal you can develop if you don't use the brakes hard enough for a long period of time, say over 2-3 weeks. But all it takes to bring back the sound of silence is to do a couple of 100km to 30km heavy brakes and things are back to normal, or attend a track day. This just help keep the rotors clean and free from any dust.

The brake wear is not too bad. The hawks I recently replaced lasted 2 and a half track days, and about 10K km of driving in between, but being an auto I think they get abused alot more than a manual. A friend had hawks on his 33GTR Vspec2 and they lasted most of the year and he attended most of the track days.

Anyway, a big :P from me.

Link to comment
https://www.sau.com.au/forums/topic/136366-brakepads/#findComment-2559256
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Echo the awesome sentiment 👍 Definitely a car worth saving. Looking forward to seeing updates as well. 
    • Scenic roads, stunning skylines, and Chickos to finish it off! Join SAU NSW as we cruise through the Royal National Park and along Lawrence Hargrave Drive to Figtree! Sunday 26th October 2025 4:30PM Meeting Waterfall Station Parking 5:00PM Cruise Departure Royal National Park > Lawrence Hargrave Dr > Memorial Dr > Sid Parrish Park 6:15PM Arrival at Sid Parrish Park Figtree Meet Location: Waterfall Station Parking Final Destination: Sid Parrish Park RSVP: https://forms.gle/E4s5SiRKQfDdypky8 *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • It's funny, as Ive seen plenty of people use them in cheap builds on YT. And they actually go okay, even though a lot of other maxspeedingrods stuff is terrible. Those turbos seem reliable enough, the only part being, a good quality turbo that is "identical" to it, will out perform it day in and day out. In both a lower boost threshold, and the ability to flow more air at the same boost pressure. As a cheap cheap replacement, not a terrible choice. For cheap and shouldn't blow in a day, not terrible (like other eBay/Temu turbos) for low cost and still decent performance, that's where the question comes in to play from the results I've seen. I'd actually find it hilarious to buy one, and strap it to a paddock basher or some other cheap as POS originally NA car, and send it to the moon!
    • The maxpeedingrods turbo is cheap and bolts on to stock parts. I think you just need a bigger silicone coupler for the intake. Its a cheap china turbo, but it's been running on mine for almost 3 years at 16-19 psi.
    • What do they look like right after you've tried to start it with everything connected? Also post photos of what they actually look like.
×
×
  • Create New...