Jump to content
SAU Community

Recommended Posts

I have a fujitsubo 3inch cat back and it sounds good.But all other skylines i hear sound angrier and throatier,not to mention louder. Why is this? Will a dump/front pipe make my car sound better? Im after the cool RB sound that is unmistakable. Anyone got any suggestions?

CHEERS

Do you have a cat?

Ans:

NO: Then probably make no differance

YES, but std:This will be drastically restricting flow, thus will be suffocating engine and robbing you of power.

I myself use a legal hi-flow cat.

My car gets very angry in traffic and yells its head off when it finally breaks free.

I like the noise but the resinating in the car sometimes gives me a head-ache.... ;)

If you want load and angry.....straight through custom 3" pipe and hot dog with no silencer.

If this is too load get a 3"resinator put on like me.

;)

Mine was just a split dump, cat then straight through to cannon.

I had to have a resonator added , the drone in the cabin was just far too unbearable. When you hit the right rpm the whole cabin would just vibrate.

No not yet but wouldnt that make it quieter?

In all probability, no.

Most mufflers work by slowing down the exhaust gas. Taking energy out of the exhaust stream reduces the noise it generates when it exits. I'm sure you've noticed that most aftermarket exhausts that are less restrictive also tend to be louder than stock.

If the cat is less restrictive to flow, its also muffling less.

I had a JASMA certified Fujitsubo cat back with centre muffler/resonator and final oval muffler with standard dump/front/cat and it was also noticably quiet when putting arond but had a deep clean note when opened up. Anything but a bark. You'll notice a lot of the cars you see with a "bark" are NA.

Dont know about other aftermarket Jap systems but what I noticed with my Fujitsubo system was that it was extremely heavy due to the fact that it was extremely thick steel, which I think helped quiet it down. I reckon it would of been 3mm thick, if not more easily as it had a decent chunk taken out in one part at least 2mm deep and it had not made close to a hole.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I had a 1981 ALFA with an electronic speedo sender that would work for months at a time, and also noth work for months at a time.
    • Yes the gear for the R33/34 is different, it is red and has a different number of teeth. My part didn't come with that gear though, so I don't know how many teeth are on the red one. You'd have to reuse the 260RS/R33 gear, as long as it's not destroyed.   Haha, as unfortunate as that might be it was working fine for about the first 1500km I've had the car for now.
    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
×
×
  • Create New...