Jump to content
SAU Community

Recommended Posts

My r33 gtst has a slight backfire when i back off the gas followed by a gargle, all coming from the exhaust. I have only had the car a week and it has always done it since then but i have put some injector cleaner in the fuel and it seems to now be worse. Is this normal for a skyline to be doing this?

Link to comment
https://www.sau.com.au/forums/topic/15218-backfiring/
Share on other sites

I haven't seen a Skyline that doesn't do it :D

Edit: Oh, if it blows lots of black smoke, this too is normal and nothing to worry about. I met someone who drives a turbo Audi and he thought that all Skyline engines were in sh*thouse condition because of all the smoke he sees them blow, I had to educate him that it was just unburnt fuel because of running hella rich.

Link to comment
https://www.sau.com.au/forums/topic/15218-backfiring/#findComment-313371
Share on other sites

Hehe, speaking of scaring pedestrians, I once scared the shite out of some bogun fat chick in my old XY Falcon with worked 302 Windsor and no mufflers. A bunch of boguns decided to meander across the carpark in front of me doing 5kph. It wasn't a pedestrian crossing, so I got a bit pissed off especially since they were in single file and walking slowly.

When the last one (fat chick) was right in the middle of my car, I floored the accelerator and slipped the clutch a little to inch forwards about 5 cm. She just about shit her pants :O

Don't think I can get the same effect happening again with the 'line :P Well, maybe if I moved forwards 1 metre instead of 5cm :P

Link to comment
https://www.sau.com.au/forums/topic/15218-backfiring/#findComment-313626
Share on other sites

  • 5 weeks later...

I drive a Turbo Audi - but im not that guy :P

'line engines are pretty awesome actually, i almost got one, but they got too common.

I know of one Audi A4 Turbo Quattro that blow a lot of smoke - but he has over 220kw at all four. So its a bit extreme. PS. watch out for him. :P

Link to comment
https://www.sau.com.au/forums/topic/15218-backfiring/#findComment-361693
Share on other sites

Does it sound angry? Yes? Then good! Mine consistanly backfires in 1st, 2nd and 3rd gear changes and often if i back off from higher up in the rev rang,Lovin it. The rumble under compression is a nice sound also. It can be controlled with longer slower gear shifts.I must admit a good Ffowing exhaust and rich fuel mixture increases this, and no cat! Oh did I say no cat? Thats illegal isn't it?? LOL

You don't want to much though as that can be cop bait...

RJB.

Link to comment
https://www.sau.com.au/forums/topic/15218-backfiring/#findComment-361879
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...