Jump to content
SAU Community

Recommended Posts

Hey, Just wanted to fill you in on a small problem that I encountered the other day. Cruising along the highway on my way to work I glanced down at my standard GTR oil presure gauge and freaked when I saw that it was just 2kg at 3500rpm. I was stuck at work and left wondering all day about all the possibilities of what could be causing the low oil pressure. I spoke to someone at Advan and was told that the standard GTR sender units give a lot of trouble and can't really be trusted and also that the N1 oil pumps have a habit of breaking the gear. So as soon as work finished I was under the bonnet attemptng to check my oil presure. I disconnected the sender unit wiring plug and noticed a bit of corrosion around the connector terminals. I cleaned off the corrosion, reconnected the sender and started the car, straight away the oil presure shot up to around 3kg at idle!! And at 3500rpm sits around the 6 - 7kg mark. They are fitted with a rubber boot over the sender plug but in my case was not fitted properly, causing the corosion.

Link to comment
https://www.sau.com.au/forums/topic/156526-gtr-low-oil-presure/
Share on other sites

2kg (no lower) is ok at idle when the engine is at operating temp, but even then as you increase the revs the oil presure should increase too. If yours doesn't move at all then at a guess I'd say that you have a problem with the sender unit. It's located next to the oil filter and is fairly easy to access. Unplug the wiring at the back of the sender, give the terminals a clean with contact cleaner (solvent) and give it a try. If that fails then I'd be checking the oil presure with a workshop type gauge and if that checks out ok, then another sender unit or an aftermarket sender and gauge. :)

  • 2 years later...
Hey, Just wanted to fill you in on a small problem that I encountered the other day. Cruising along the highway on my way to work I glanced down at my standard GTR oil presure gauge and freaked when I saw that it was just 2kg at 3500rpm. I was stuck at work and left wondering all day about all the possibilities of what could be causing the low oil pressure. I spoke to someone at Advan and was told that the standard GTR sender units give a lot of trouble and can't really be trusted and also that the N1 oil pumps have a habit of breaking the gear. So as soon as work finished I was under the bonnet attemptng to check my oil presure. I disconnected the sender unit wiring plug and noticed a bit of corrosion around the connector terminals. I cleaned off the corrosion, reconnected the sender and started the car, straight away the oil presure shot up to around 3kg at idle!! And at 3500rpm sits around the 6 - 7kg mark. They are fitted with a rubber boot over the sender plug but in my case was not fitted properly, causing the corosion.

the n1 oil pumps are strong.. its the standard oil pumps that tend to brake the gears

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sorry to hear your HFM BM57 was faulty,  did you contact HFM I would hope they would be at least grateful for the information if there was some sort of manufacturing fault, you would hope they would be sympathetic even if your item was 2 years old if it had never been fitted. May I ask where it leaked from ?
    • Cats are called Bella, and Donna...  Like that poisonous plant And I remember your 2 monsters, I remember making a little bit of wee when you let them out... LOL I have already installed cat doors into the laundry where their kitty litter is, and the sun room, apart from the cat doors there's not going to be any permanent mounted stuff on the interior walls (interior doors are cheap and easy to replace) I will get a outdoor cat cage thingie once I finish the landscaping out back... https://catnip.com.au/ The only off limit areas are the main bedroom and the gym room....but, currently the cats are curled up in bed, in the main bedroom with the Mrs.....LOL, the off limits for the kittens to the main bedroom lasted about 5 minutes with Jackie I currently only have 1 free standing huge cat tree multiple level scratching post thingie in the lounge room, but, I will be getting another one soon now that I'm happy with the furniture layout in the back room and have a perfect spot for it  
    • All of this is making it seem clear that running the Coppermix twin was definitely the way to go, especially in hindsight with how insane tariffs have gotten and the strength of the USD vs yen at the time.
    • That sounds like no chance of even importing one for road registering then Now I see why Duncan wants to check LHD rules for Targa...   I wonder how "bolt in" the AWD would be if you got one imported from the US and swapped it to an AUD one
    • Not to mention they drive like a bucket of bolts! yuck!
×
×
  • Create New...