Jump to content
SAU Community

Recommended Posts

this is my dream 32 4 door. except it would have to have a stock GTR kit all over it. even the stock rims finish it off nicely.

if i got around to it id make the rear wide body spec like the GTR thoe. not easy when you have a door to include.

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

Stock kit going on next month :P and the rear is rolled as far as you can take a 4 door. If you saw how much addon rear guards were for 4 doors, you'd probably choke ;). Although you can get them :(.

Meisters weren't mine and long gone :).

Vivagarge has the rear wide quarters for a 4 door

$480 for both sides

its 4 pieces one on quarter and one on door on each side

they arre 25mm wider

i had seen a set once on yahoo actions but that was it. but 25mm is hardly enough to notice.

i think the best would be to buy the gts to GTR rear guards off car mate. they only go on the lower half of the body work just like the GTR and mate that suit a 4 door.

anyway good luck with it.

  • 7 months later...

While I wait for the GTR bar to go on with Grill (woot finally) I thought I might post an update about the car. Recently got the car tuned down at Status in Victoria and it went from 200rwkw to 245rwkw. Apparently one of the, if not the, highest power out of a 'stock' 26 at 14psi Status has seen :P.

post-15588-1257747144_thumb.jpg

post-15588-1257747163_thumb.jpg

I have cam gears sitting on the passenger seat but was recommended that they are largely a waste of time. And it's getting a lot more road time now :). Also forgot to mention I have since put a Nismo super coppermix twin plate in, awesome clutch.

  • 1 month later...
  • 2 months later...
  • 4 weeks later...
  • 4 months later...
  • 1 month later...

No pics of the interior atm because it's sort of unfinished. And the engine bay isn't particularly exciting because i've gone out of my way to make it stock looking (well except that the covers are all painted blue :blink:). Will try and get something though.

Last weekend at the top of buller sub 3 degree weather fresh after a detail.

IMG_1929800x600.jpg

Copyright Basti.

  • 4 weeks later...
  • 10 months later...

Thought I might give an update.

Car has been good, just fixed up a few annoyances like the power steering setup and mounted the gauges. I've put some brembos on and 33R rims to clear them.

post-15588-0-26780700-1317797035_thumb.jpg

Also transferred a few goodies over to the daily as things get updated :).

post-15588-0-98944700-1317797278_thumb.jpg

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hi. This is just my curiosity because iam sure the tuner figure something out...but either way i want to ask. The "problem" is that the Nistune ECU (Stagea FW and RB25DET NEO from Stagea) sees many times the speed than the speedo does(he says the speedo show 120 km/h - correct speed and the ECU shows like 510km/h ) I told him that this car/tranny getting speed from rear diff. If iam not mistaken the RB25DET NEO "need" to see tranny speed sensor? (my tranny has the plug for it). So couple of "question" If he connects/wire the speed sensor to the tranny...are the signals gonna intervene and if...what if he disconnects the rear diff one and the speedo stops working? Or the "new" sensor from the tranny "take over" and will not going need the one from diff? As i said i know he figure/get that done...iam just curious to know what are the solutions 🙂 
    • Your IACV is set to idle too low. You need to adjust it via the screw Duncan mentioned. From memory it should be 650rpm with the valve electrics unplugged. What is it trying to idle at with the IACV plugged in?
    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
×
×
  • Create New...