Jump to content
SAU Community

Recommended Posts

Hey all, was driving along and my car started running rough so i pulled over, it sounded like i was running a huge set of cams. I turned it off and waited a while and then started it again it ran rough and thenit smoothed out so i drove it slowly home and parked it

I then started it again and it was running like shit and then it just died on, and now it wont start.

I change the fuel filter but that was just wishful thinking.

What do you think it could be.

It runs a Ltx 12 microtech so it has no AFM.

Thanks guys.

Link to comment
https://www.sau.com.au/forums/topic/158467-it-just-stopped/
Share on other sites

Does the engine turn over? Electrical fault? Charge in the battery? If electrical fault is messing with the ignition, the engine may be dropping a cylinder or two causing it to run rough? Dunno, just guessing from the info you've given.

Link to comment
https://www.sau.com.au/forums/topic/158467-it-just-stopped/#findComment-2942156
Share on other sites

Does the engine turn over? Electrical fault? Charge in the battery? If electrical fault is messing with the ignition, the engine may be dropping a cylinder or two causing it to run rough? Dunno, just guessing from the info you've given.

Yeah i know mate it could be anything its a hard one, just wondering if this has happened to someone before.

No the engine wont turn over, but i have ignition and fuel.

And another thing it had a wierd burning smell coming from the engine so maybe it is electrical.

Link to comment
https://www.sau.com.au/forums/topic/158467-it-just-stopped/#findComment-2942241
Share on other sites

are you running a plug and play adaptor with the microtech? ive had this problem once, car did same shit, id say the cylinder are full of fuel and it wont start, take the plugs out and or make the injectors not pulse, then crank crank crank it for ages till it clears, best bet is to take plugs out, then goto your ecu and make sure all the pins are in place and theyre touching all the time.. i.e wiggle the harness and make sure it doesnt cut out....

Link to comment
https://www.sau.com.au/forums/topic/158467-it-just-stopped/#findComment-2942555
Share on other sites

Thanks for all the advice so far i will try it all tomorrow.

I was just driving the car normal around 3-4000rpm going up a hill.

^^ i run a MSD ignition with a Ford coil pack.

Edited by subzeroR33
Link to comment
https://www.sau.com.au/forums/topic/158467-it-just-stopped/#findComment-2942689
Share on other sites

Its all fixed, checked the spark plugs they were covered in a sticky oily black sludge.

I didnt think to check them as they were irridiums put in about 12,000 km, they are spose to last 100 000km.

Anyway i will be saving my money in future and just buying the normal copper plugs for around $20 not $120.

Link to comment
https://www.sau.com.au/forums/topic/158467-it-just-stopped/#findComment-2959444
Share on other sites

you're not worried as to why they were covered in oily sludge?

Well the microtech would have something to do with it, the injectors just flood the thing on start up so i spose over time they just foul up and probly to much upper cylinder lubricant.

Will keep a close eye on the plugs this time if they foul up to quick then i will need to fix this problem.

Link to comment
https://www.sau.com.au/forums/topic/158467-it-just-stopped/#findComment-2965356
Share on other sites

It was playing up again today, does this sound like an issue with the coils.

It misses and then comes good, short time later it missesd then comes good. It is really shiting me now.

check your crank angle sensor plug might be coming loose or not plugged in properly or there is a short in the wiring, i had similar problem on my old mans 32 gtr where plug seemed to be plugged in but wasnt fully clipped in, it caused rough running and a really bad miss. I checked the plug and clipped it in properly and problem was solved. Also check if you have a good connection at the battery/ground to ecu is very important. And yes it could also could be a coil starting to break down especially if you are using a ford one :ninja:

Edited by drf76
Link to comment
https://www.sau.com.au/forums/topic/158467-it-just-stopped/#findComment-2968679
Share on other sites

check your crank angle sensor plug might be coming loose or not plugged in properly or there is a short in the wiring, i had similar problem on my old mans 32 gtr where plug seemed to be plugged in but wasnt fully clipped in, it caused rough running and a really bad miss. I checked the plug and clipped it in properly and problem was solved. Also check if you have a good connection at the battery/ground to ecu is very important. And yes it could also could be a coil starting to break down especially if you are using a ford one :)

I will check it out. Im also getting a knocking sound from the injectors. May be a fuel thing to.

Yeah i know Ford coils :ninja:

Link to comment
https://www.sau.com.au/forums/topic/158467-it-just-stopped/#findComment-2968713
Share on other sites

I will check it out. Im also getting a knocking sound from the injectors. May be a fuel thing to.

Yeah i know Ford coils :ninja:

haha ford, i work for them but anyway yer could be injectors but when you said your spark plugs are pretty bad you tend to think its spark related, but you gotta somewhere, hope you find out what it is soon with out too much hassle :)

Link to comment
https://www.sau.com.au/forums/topic/158467-it-just-stopped/#findComment-2968723
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I’m here solo don’t have any hands to help so haven’t hit it with a timing light 
    • When you crank your car, and hit it with a timing light, can you see a steady crank timing?
    • Oh, forgot to add, A few months ago I was getting mixture codes and the car was using crap loads of fuel. You could smell the unburned fuel in the exhaust, it was crazy strong. Economy was over 17.5 l/100 and usually around 19. I smoked the engine and found a leaky CCV hose which I replaced and then I replaced my two pre cat O2 sensors, I also replaced the MAF. This fixed my mixture codes and improved my exonomy but I'm still 14 - 15 l/100 when pottering about town so something is still amiss. Throttle response is much better and it has more pep but I'd like to know why it's still so thirsty (and I'm hoping that whatever it is gives me a bit more poke).    
    • Car is on factory injectors/z32 maf/ q45 throttle body/ z32 ecu with nistune 
    • Hello all, currently finishing up a rb25 swap into my s14. Having issues with starting, car has spark (confirmed by pulling a plug and watching it spark), has fuel(confirmed by checking pulse/voltage at injectors all spark plugs are soaked in fuel). Car cranks over and pops into the exhaust with a heavy fuel smell but no attempt to start or run, I have torn the timing cover off and triple confirmed timing, turned the CAS in multiple spots both directions, attempted to start with coolant temp and maf unplugged, checked my fuel lines and made sure they weren’t backwards, checked voltage at cas/injectors/coilpacks, made sure all the grounds in the harness are connected and added a few grounding straps (1 from chassis to block, 1 from chassis to head, and 1 from chassis to igniter chip) I am getting stumped here. As a last ditch effort I made a full grounding harness tonight that’s going to run from the battery and add an extra ground from the battery onto the coil pack harness/igniter chip/ intake manifold/ Wiring specialties harness ground/ and alternator. I’m hoping maybe the grounding harness will fix it here but posting here to see if anyone has any other ideas on what else I can check. My fuel pressure is unknown right gauge will be here tomorrow.  IMG_3206.mov
×
×
  • Create New...