Jump to content
SAU Community

Recommended Posts

Okay guys,

I'm getting misfiring under load while on boost, and I fear it's pinging also, I've never heard pinging before, but it's very faint and hard to hear over the pod's sucking noise.

My question is,

How do I use a timing light to check the timing degree's ?

there is three connectors coming out of my timing light...

One set goes to the battery,

One is the inductive pickup

the other is an alligator clip which used to go somewhere on the coil in my old-old car

my question is: where do I connect these on the skyline ?

It's a 1995 model, so it doesn't have the large ignitor module at the top-back of the plug covers. it just has two electrical connectors together. Do I clip in on the entire loom, or one wire in that bunch ?

How do i tell what the base timing is? in Degrees ? The main cranky thing has (i think) 5 notches marked on it, the far left is yellow and the other 4-5 are white. how do i line these up and retard-advance timing ? what's the deal ?

any help would be greatly appreciated :P

Link to comment
https://www.sau.com.au/forums/topic/15859-timing-light-tune-how/
Share on other sites

I usually do it in the following manner:

- take that u shaped hose off (the one sitting on top of the covers at the front of the engine)

- unscrew the first 4 allan bolts on the plastic cover, that hides the coil packs

- lift cover witha flat head screwdriver

- put u shaped hosw back on

- use the inductive pickup on the wire going to coil pack #1

after adjusting your timing, just put it all back the way it was.....

Also make sure your revs are at 650 when doing the timing, and when you have set the timing..... Use the screw on the drivers side of the plunum , right at the back, facing out the side of the car...

clockwise to decrease revs, anti clockwise to increase.

the first mark is 0 deg. Each subsequent mark is another 5 deg. Nissan recomends you set your timing to 15 deg (which would be the third white mark).

I usually set mine to 17 or 18. I can get it that far with very little pinging, but not past 18. Like I said, make sure the revs are also at 650rpm.... it will change as you advance/retard timing.

Hope this helps

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...