Jump to content
SAU Community

Recommended Posts

hey peeps my friend is looking at a r32 to buy and the guy has $10,500 on it. Just wondering if you guys think this is too much or not.

I've listed details below and we took a pic:

Model: Nissan Skyline 1989 4 door GTS-T

Engine: RB20DET

Km’s: 156000

Paint: Dark blue. Needs slight patch up on drivers side near rear wing and on rear bar just below boot.

Body kit: Stock. Fibreglass bonnet with carbon fibre overlay

Wheels: Stock 16s.

Tyres: Front Nankang. Rear: Yokohama A Drives

Engine Accessories: GFB Blow Off Valve. APEXi pod filter. Boost is running at 11psi. Aftermarket exhaust

Suspension: Tein coil overs all round.

Interior: Steering wheel is a bit ratty due to age. No front speakers. Rear speakers aren’t properly secured just been too lazy to do it. Aftermarket boost gauge installed in air vent.

Link to comment
https://www.sau.com.au/forums/topic/164732-89-r32-gtst-sedan/
Share on other sites

Sedans are less popular, and 89's are the oldest of the lot. If that car is an auto it is deffinately over priced. If not considering how stock it is and its age, id be aiming to get it for $9k if its in good nick.

its manual. its in great condition apart from the 2 spots where the paint is bad and the steering wheel. almost brand new tyres on the rear (so obviously its probably been flogged or just alot of wear) but we've had it checked out n the mechanic reckons its in top shape

$10,500 is a bit much IMO considering the km's on it.

There are a few on carsales for $10,000 with under 100,000kms..

(But then some people don't care about km's as much as I do.)

Edited by so_tred
$10,500 is a bit much IMO considering the km's on it.

There are a few on carsales for $10,000 with under 100,000kms..

(But then some people don't care about km's as much as I do.)

All R32 GTS-T's are between 14 - 18 years old. If you think a car of that age has less than 100,000km (which means it has done less than aproximately 7000km - 5500km per year!!) then good luck to you. Most of the skylines brought into Australia are wound back. I would never buy an r32 that had less than 100,000km and think that the k's were genuine...

So when it comes to skylines the number on the dash means little. You need to assess the condition of the car and engine and get it inspected and judge for yourself.

All R32 GTS-T's are between 14 - 18 years old. If you think a car of that age has less than 100,000km (which means it has done less than aproximately 7000km - 5500km per year!!) then good luck to you. Most of the skylines brought into Australia are wound back. I would never buy an r32 that had less than 100,000km and think that the k's were genuine...

So when it comes to skylines the number on the dash means little. You need to assess the condition of the car and engine and get it inspected and judge for yourself.

I think there would still be a few with genuine low kms..not many but a few.

I have an r32 sedan for sale as well. puttin new (genuine 120,000km) motor in it as we speak.

Odo reads 120 (beleive it was wound back) Mechanically it is in top shape.

http://www.skylinesaustralia.com/forums/in...p;#entry3012380

few months ago i saw an 89 GTR for sale @ carsales.com.au with 300,000kms...... :P

Your point? :)

People can say all they want but I had an 89 Silvia that was a straight import which I got in..04? It only had 20,000km on the clock. Don't try and argue because I had the servicing books and 2 mechanics have since had a look (because it's been pulled apart recently to have an RB20 dropped in) Both have said that the odometer hasn't been touched..& coincides with the overall condition of it at the time.

Edited by so_tred
Your point? :(

People can say all they want but I had an 89 Silvia that was a straight import which I got in..04? It only had 20,000km on the clock. Don't try and argue because I had the servicing books and 2 mechanics have since had a look (because it's been pulled apart recently to have an RB20 dropped in) Both have said that the odometer hasn't been touched..& coincides with the overall condition of it at the time.

Then y are u doing an engine replacement?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
    • Thanks for the replies everyone. Definitely a coolant push. Oil catch can is empty and always has been. As the engine is out now I'll be having a good look over things. I do have some detonation on the piston tops from a trigger issue back about 5 years ago. I felt it and shut off then bought a new ecu and changed the trigger. Never been an issue since. It never hurt the power, its made almost 80hp more since that incident but I will pull the bearing caps to take a look. If the bearings are damaged I will do a bottom end refresh. Head is being re conditioned at the moment and the block will be cleaned and checked to ensure it's flat. I'll go with a kameari gasket and see how it ends up. The other thing I'm not super keen on is the cylinder colours. I suspect this is from the inlet manifold. The plan will be to put it back together, retune and then stick a plazmaman billet inlet on it and retune. I'm happy with the power, if it makes a little more, then great, but I would rather just make everything more efficient at this stage.
    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
    • Does it also misfire equally when revving?   Josh is very correct in what you should do. The coilpack harness wiring loom itself is a known problem due to its age and the number of heat cycles it has gone through. Throwing parts at a vehicle to diagnose the issue isn't a smart or good way to do it. Secondly, you may have a bad coil pack, you pop replacements in, they fix that issue, but messing with the harness breaks it, so the issue persists. So now you think "well it wasn't the coil packs" and have to continue chasing your tail, potentially swapping back in your shit coil packs and returning the good ones (yes, I've seen people do this because 'it wasn't the problem' and they want to save money). And suddenly, you've got two issues with the same symptoms...   Diagnose, don't use the spare parts shotgun.
×
×
  • Create New...