Jump to content
SAU Community

Recommended Posts

Ok all,

I was at the track last Friday and lost my power stearing at the end of a pass and the HICAS light came on. When I got home I

replaced the power stearing pump and also replaced the HICAS

switch behind the stearing wheel. My question is how do I get my

power stearing back????

It is still not returned and I'm about to replace the sensor contected to the HICAS pump on the RH side of the engine bay next to the oil filter. I had a shop do a diagnostic on it and they said that the stearing wheel switch was bad so I replaced it but

their is no differance. Still no power stearing and damn light is still on!!!

HELP..............SOS....

Eric

Link to comment
https://www.sau.com.au/forums/topic/16730-hicas-problem/
Share on other sites

The most common cause of P/S loss and HICAS light on is a minor loss of P/S fluid. Topping up the fluid will usually cure it. (A 'search' through these forums would have found this)

But since you have gone overboard with the fix, are you sure there's no air trapped in the P/S system?

Link to comment
https://www.sau.com.au/forums/topic/16730-hicas-problem/#findComment-344198
Share on other sites

Guest GGGodzilla

Ericherm1, could you email me and let me know how you go? I've had a similar problem with my car. The HICAS light comes on after a while while driving.

I've only had my car on the road for about a month (fresh import) and I'd like to sort it out.

[email protected]

Thanks Rob.

Link to comment
https://www.sau.com.au/forums/topic/16730-hicas-problem/#findComment-345660
Share on other sites

The fluid level was the first thing I checked and double checked and the level and all is good.

How would I go about purging or bleeding my power stearing system, if their is an air bubble?

I'm only down to 3 more options left as I see it,

Replace the cut off valve attached to the HICAS sylinoid,

Replace both left & right sylinoid,

Replace the HICAS computer in the rear deck.

???

Thanks,

Eric

Oh yeah, (off subject) my car ran low 11's that night too....hehe

Link to comment
https://www.sau.com.au/forums/topic/16730-hicas-problem/#findComment-345870
Share on other sites

RAB....... thats becuase the computer has not received any input from the steering wheel for a little while. Its not a problem when that happens. Could also be that you have a aftermarket wheel on and not got the proper boss kit. Get the right boss kit and prob will be fixed.

Ericherm is it possible that you need to get the errors cleared from the ECU? I have the exact same problem and have been chasing my tail around forever trying to fix it. Please let me know how you go.

Link to comment
https://www.sau.com.au/forums/topic/16730-hicas-problem/#findComment-350765
Share on other sites

ok.... let me say this:

I already have the correct boss kit, and I know where all the parts are on the car, to include the power stearing resivor, and its filled to the proper capasity.

Like I said before I already replaced the rotation sensor in the stearing column, and the power stearing pump itself. But I still have the problem with no power stearing. Parking is such a pain with no power stearing!

Sorry to sound firm but i'm very frustrated right now,

oh and ..lol

Eric

Link to comment
https://www.sau.com.au/forums/topic/16730-hicas-problem/#findComment-353770
Share on other sites

Well I think I am going to just buy a HICAS Cancel Kit and lock

the rear end and then just unplug the HICAS Computer.

I tried unpluging the HICAS computer yesturday and I got my power stearing back. But when I pluged it back in it was gone

again.

Anyhow my mechanic did the diag test and found out that the HICAS computer is in safe mode, and we cannot figure out how to get it out.

Link to comment
https://www.sau.com.au/forums/topic/16730-hicas-problem/#findComment-354516
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
    • Shock tower brace is in +5Kw....LOL  
×
×
  • Create New...