Jump to content
SAU Community

High Temp Coating Of Exhaust Housings And Manifolds.

Abo Bob

By Abo Bob,
in Group Buys

 Share

Recommended Posts

  • 4 weeks later...
Bliksem Veteran

Bliksem

Posted
Posted

Sent my manifold and turbo housing off to Stuart today for the black treatment, was only to happy to explain the process to me and was quick to point out a discount after I mentioned SAU.

Will post up a few pics when they're back at home.

tridentt150v Grand Master

tridentt150v

Posted
Posted

Just got my HKS cast low mount, HKS wastegate and base plate, and my turbo exhaust housing back from Stuart at Procoat.

I'd just like to say top service, Stuart was more than willing to talk about the job, kept me informed all the way, all bolt holes and area's that needed masking off were done and the finish is spot on.

I also got an SAU discount.........he said he would look after anyone from SAU.

I couldn't be more satisfied. I dealt with him via email, post and phone and it was no problem.

Thanks Stuart, trader rating left.

  • 2 weeks later...
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • feartherb26
      RB25DE NEO with Haltech ECU

      By feartherb26 · Posted

      If you take the top half of the intake off you can unbolt the flap off the shaft and leave the shaft in there blocking the hole. Then you can remove the little vacuum canister off from under the manifold and get a spare vacuum line to run to the ECU. I can take some photos of it later. Probably best to get the vacuum source to the ECU sorted first though. Mine all worked mint with the base map from the GTT an I've pretty much let the closed loop sort the fueling and took 1 degree out of the whole timing map.
    • Kinkstaah
      RB25DE NEO with Haltech ECU

      By Kinkstaah · Posted

      This IS something you also have to configure in Haltech (or at least I did in the past when going from onboard-to-ECU map sensor and an external MAP sensor in haltech land).
    • Murray_Calavera
      RB25DE NEO with Haltech ECU

      By Murray_Calavera · Posted

      I'm hoping it's something as simple as the ECU is looking for an external MAP sensor, but he is trying to use the onboard MAP sensor.
    • Murray_Calavera
      RB25DE NEO with Haltech ECU

      By Murray_Calavera · Posted

      You won't need to do that if your happy to learn to tune it yourself. You 100% do not need to do that. It is not part of the learning process. It's not like driving on track and 'finding the limit by stepping over the limit'. You should not ever accidently blow up an engine and you should have setup the ECU's engine protection to save you from yourself while you are learning anyway. Plenty of us have tuned their own cars, myself included. We still come here for advice/guidance/new ideas etc.  What have you been doing so far to learn how to tune?
    • GTSBoy
      RB25DE NEO with Haltech ECU

      By GTSBoy · Posted

      Put the ECU's MAP line in your mouth. Blow as hard as you can. You should be able to see about 10 kPa, maybe 15 kPa positive pressure. Suck on it. You should be able to generate a decent vacuum to about the same level also. Note that this is only ~2 psi either way. If the MAP is reading -5 psi all the time, ignition on, engine running or not, driving around or not, then it is severely f**ked. Also, you SHOULD NOT BE DRIVING IT WITHOUT A LOAD REFERENCE. You will break the engine. Badly.
×
×
  • Create New...