Jump to content
SAU Community

Recommended Posts

well ive been looking into getting a bov and was looking at the greddy ones. will they fit to the stock pipe where the bov is now. if not what do i need to make it fit. also where could i put it and replace the pipe thats on there now. and the black rubber pipe thats going into that silver pipe what is that. if i want to replace that silver pipe for a polished pipe do i need to still have that rubber pipe if i move the bov to another location? hope thats not to confusing.

engine2.jpg

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/
Share on other sites

  • Replies 80
  • Created
  • Last Reply

Top Posters In This Topic

The Greddy ones will fit in the stock location, you'll need to tap two holes

As with the backfiring and stalling, if you tighten it up enough, reset the ECU and drive it for a bit you should be fine, but even then, once in a while it can stall

Also in some states in Australia it is illegal, here in NZ it's fine, but they sound pretty wanktastic so why bother, unless you are running a lot of HP and an ECU that can adjust the fuel mixture so the engine leans out when changing gear to accomodate the air rushing out of the BOV and not returning into the intake

Just add a POD filter, it'll give you the same kind of noise

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/#findComment-3297294
Share on other sites

i recently put an atmo bov on my crossover... car was running pretty crappy, but i went round and tightened and changed my hoses and runs well, but as R31nismoid could make it run poorly, backfire or stall, but if thats the case its a matter of adjusting your driving style to suit...

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/#findComment-3297296
Share on other sites

as skybarge said you can get a pod filter and block up where the bov goes... i at one stage had my bov disabled and with the HKS pod i had a mad flutter sound and loud too... but some people may tell u it can harm your turbo as the flutter sound is air getting pushed back into the turbo and getting cut up...

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/#findComment-3297300
Share on other sites

sorry to hijack, i didnt think you could adjust the ssqv's? either way going atmo on mine the car would randomly stall(sometimes going around corners at 8o ks, very scary) but eventually the ecu worked it out and i havent had any trouble for months

Yep.

The SSQ have a screw at the top which is the adjustment screw.

If you wind that screw in it will open on higher boost/high RPM as it requires more pressure, and if you wind that screw out that will release the tension on the BOV and it will open up on a lower boost/RPM.

Its more like a bolt rather than a screw, and it has a little nut on it in-between the head of the bolt and the surface of the BOV.

Hope that helps :laugh:

Thanks,

Abu

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/#findComment-3297387
Share on other sites

All I know is that as your dumping the air that the AFM has already measured the ECU will crap itself regardless of the tightness of the spring. The only BOV which i have seen that tries to combat this AFM problem is the GFB Stealth where you can adjust how much air is vented to atmo and how much is plumbed back. But.... you are still dumping air the AFM has measured hence the ecu will compensate by overfuelling so causing stalls,backfires etc. Ive heard of people purchasing Fuel piggyback computers like the Apexi SAFC. If you want the noise then go for a pod but then u'll encounter another list of dilemnas.

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/#findComment-3297627
Share on other sites

Thanks for the info guys, i am currently having my GTS converted to rb25det and was wondering about the problems with BOV's good thread with good information, i was thinking about going to GFB stealth because of its adjustability, I will be running:

rb25DET

After market Hybrid FMIC with alloy piping, Apexi Air Pod, Apexi Full auto timer for NA and Turbo.

Recommendations?

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/#findComment-3299925
Share on other sites

rofl, another BOV thread.

Stock one:

Car won't stall

Car won't backfire

Cops won't defect you

You'll drive around and sound normal

After Market Vent to the atmosphere, whooshspinning twirly hurricane attention attracting one:

Cops will defect you

Cops will go harder on "jap" cars because you're another person with a big loud whoosh, trying to be a dickhead

Car will stall

Car will backfire

Car will blow flames, cops will defect you

Chicks will hear it, get instantly wet, and come running at your car wanting sex

Everyone around you will immediately think your cool and want to be your friend

You'll foul your spark plugs

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/#findComment-3299985
Share on other sites

plumb back is the best recommendation for everyone, atmo bov's and blocked bov's get annoying after a while and like everyone said theres not much benefits to them

i understand if you have a SR20 its a bit harder to make a return pipe for the bov, but for the skylines i think its easier to remake one cos the standard return pipe is like a pea shooter that bends and turns 100 times

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/#findComment-3300019
Share on other sites

Chicks will hear it, get instantly wet, and come running at your car wanting sex

Everyone around you will immediately think your cool and want to be your friend

omg bro dat's so true uleh! Jus like ma cousin habib's vl. Da chick's luv it fully hectik uleh.

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/#findComment-3300044
Share on other sites

rofl, another BOV thread.

Stock one:

Car won't stall

Car won't backfire

Cops won't defect you

You'll drive around and sound normal

After Market Vent to the atmosphere, whooshspinning twirly hurricane attention attracting one:

Cops will defect you

Cops will go harder on "jap" cars because you're another person with a big loud whoosh, trying to be a dickhead

Car will stall

Car will backfire

Car will blow flames, cops will defect you

Chicks will hear it, get instantly wet, and come running at your car wanting sex

Everyone around you will immediately think your cool and want to be your friend

You'll foul your spark plugs

have u got proof backing up all those claims????

cops WILL defect you regardless of stock bov if they wanted to, when i had a atmo bov i did not have problems stalling, or shooting flames, or being defected.

if ur gonna be a dickhead shooting your BOV every gear down every street passing every person, expect to get it.

but if ur smart about it (not making the bov crome so it stands out in the engine baY) and driving normally. its fine

Link to comment
https://www.sau.com.au/forums/topic/181546-another-bov/#findComment-3300062
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Haha, i kow right? Could have bought so many cars for the same amount of money (or less) but driving Unicorn gives you at least +1mln to style 😅. Like wise man said "life's to short to drink cheap wine and drive boring cars" 😉
    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
×
×
  • Create New...