Jump to content
SAU Community

Recommended Posts

I dunno whats wrong. Driving well one day. Not starting the next morning.

Here are the symptoms. mind you i dont know what everything is under the bonnet.

Cant start the car. at this point it seems like a typical battery failure. not enough voltage. and seems to need replacing.

Hicas light is on once i jump start the car. Power steering seems to be off.

Hicas light flickers and then goes away when i accelerate enough and power steering then returns

When i brake the Voltage on the battery Goes from 12 volts to about 4-6 volts and power steering goes off.

When i accelerate the Voltage on the battery goes back up to 12 volts and power steering goes back on.

This mind boggles me. please help me figure out whats wrong. otherwise ill just have to head to the mech. tho i prefer to fix my owns problems... when i know what they are!

Help!

mabye a grounding problem in the hicas unit, have you touched anything reacently?? has the hicas ever been played with if so mabye a grounding nut or bolt wasnt tighetened enough and has vibrated off?

im just guessing i have no clue just something to check

Check ALL the front belts, FAN, ALT, Power Steering, sounds like they are slipping bad and maybe battery is stuffed as well?

LOOK CLOSELY AT YOUR TERMINOLOGY AND CLARIFY your symptoms.

Skylines are EXTREMELY sensitive to voltage. If you sudeenly lose voltage to any of the ECUs floating around in the car, they will start to misbehave.

Replace the battery. And check the alternator and the fan belt.

Hey dude sucks about the issue.

your HICAS light might be coming on because you are running low on power steering fuild, they used a shared resivour. what you need to do is get some power steering fuild from super cheap or repco and top up the fuild level.

your power steering fuild is located towards the front of the car just next to your front passenger side wheel. its like a medium sized can looking thing with red fuild in it.

in regards to the voltage issue, because of the high reving nature of the RB engines the alternator wont start turning over until you hit 2000+ RPM so give it a solid blip and see what volatge is carries maybe?

good luck.

Had the exact same fault last night in my car.

Threatened to not start this mornig but did go so being the lazy unadventuruos type

I took it straight to the auto-electricain.

Turns out it was the alternator worn bushes or some such thing.

Alternator to be serviced no major dilemma or cost.

Hopefully it's nothing more sinister in your case.

Definitely check your battery first, then the grounding (negative terminal), and then your alternator - one of the diodes could be busted (problem happened to my Bluebird - the only way i got it home was too keep the engine revving as it suddenly failed) - the best solution is to buy a reconditioned or a new alternator.

I have had similar problems - turned out it was the wiring to the battery was corroded. There are a multitude of connectors on the positive cable going to the battery. touch them to see if they are warm - if so probably a bad connection, disconnect and clean them out.

good luck

Hey everyone. thanks for the replys and all the help.

here's what i've found so far.

I've checked the belts and even spray a 'belt grip' spray on them and it doesn't look like they're slipping.

I found that when the jumper leads were still connected to the 'other car's' battery, the car worked fine without revving.

so i replaced the battery ($15 for a used but still good 480 battery)...

Problems fixed. or so i thought. it was running normally again. the voltage remained at a constant 12V. then a few days later. voltage goes to about 9V and the hicas light comes back on. Yep. same problem.

Im either going to source a used & working alternator or just get my current one fixed.

does anyone know how much it costs to get my alternator reconditioned... or bushes fixed?

if you need to jump the car every time to start it, the battery is not charging. Make sure all connections are tight and jump it, drive for 30 min or longer, and that should be that. find a new alternator if that doesnt work, or a reco, either way you wont be installing it the auto electrician will

  • 3 weeks later...

Finally got a used replacement alternator like a week ago... and i put it in myself. That was a lil tough, only because its a bit of tight place to get to under the bonnet but it wasn't too hard. I could do it again, easy.

Problem's fixed. been driving for a few days now, its recharged the 2nd battery that i ran flat, All good! and costing me a total of $40 for alternator, and $15 for battery. battery was a good condition used 470 CCA. =P im happy again

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...