Jump to content
SAU Community

Recommended Posts

Hey Pete, ever thought of going standard pump as a pick up and a bosch 044 as a external pump with a surge tank?

Im thinking of doing something like this with my build. Should be more then enough fuel i should hope.

yeah but there you've got the inevitability of E85 and needing bigger injectors again like Joel said saturday might as well bite the bullet and get 1000's

yeah spoke to hime briefly on Sat about that.

He mentioned something about 800cc with twin sprays (not avail in 1000cc).

Don't think 400kw + E85 = 800cc unfortunately though

Hey Pete, ever thought of going standard pump as a pick up and a bosch 044 as a external pump with a surge tank?

Im thinking of doing something like this with my build. Should be more then enough fuel i should hope.

yeah I reckon you're right Luke.......to play it safe anyway

External Bosch is approx $250........have you checked out any decent surge tanks.........haven't really had the need to look into them until now.

DSC00136.jpg

ive never seen an rb20 set up like this :laugh:

rb20det Engine variations:

The rb20det came in two different forms, the earlier red top with the NICS system and the newer silver top version with the ECCS system. The red top is the earlier version of the rb20det and came as standard with the r31 skyline, z32 fairlady and the nissan laurel, whilst the r32 skylines and nissan cefiro came with the silver top version.

Just to confuse you more there were a few red top rb20dets with the eccs system, heres some engine power outputs.

RB20DET red top

1986-1987: 178bhp (NICS version)

1988-1989: 190bhp (ECCS version)

RB20DET silver top

1989 onwards: 215bhp

never seen that setup on a 20 too..would give better response as the piping is significantly shorter however i reckon that cooler would be getting major heat soak as my 20 generates quite a bit of heat ontop of the cam/rocker cover

Im thinking maybe get AM performance to make one up. If your keen to get one, we might be able to get two cheaper.

I'll have a look on some Jap sites to see if anyone makes them over there.

DSC00136.jpg

ive never seen an rb20 set up like this :/

Z31 200ZR (basically the old school fairlady with povvo NICS Redtop RB20DET with top mount cooler)

Id rather poke myself in the eye with a rusty needle before driving another NICS RB20DET

as a mate of mine has in his msn name: NICS is japanese for FAIL

Im thinking maybe get AM performance to make one up. If your keen to get one, we might be able to get two cheaper.

I'll have a look on some Jap sites to see if anyone makes them over there.

hey luke how much do hks 700cc (740cc??) usually go for????

just curious on the retail price compared to the price they gave me on them....

hey does the z32 afm have mesh on both sides? stupid question i know but just want to make sure before i buy.. im guessing it doesnt but not sure =/

yes they do im guessing your looking at a ebay job they normally tear off the mesh to clean the wire buyer beware :/

Craig, i had a Redtop NICS in my 31 a few years back

nothing but issues, and a poor breather of an engine (the fingers of the inlet runners are about half the size of a silvertop 20det runner...........not cool). i think i made a massive 76rwkw with a RB25 turbo strapped to it that was making 5psi LOL

oh yeah, and once i popped it and stripped it for parts to sell, this is all i had left

DSC00029.jpg

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There's a good German place in Brisbane if youre up for the drive 😛
    • The German place in Cabramatta was rock solid, fresh pretzel cooked to order back then. Then it went all quiet, after all the poker machines were removed, then I believe it closed for good. I did drive past the other week and noticed outdoor lighting a big screen, but no idea what is there now.  
    • Yeah I suspect even if you hold airmass per cycle/cylinder constant if you get too far away from stock you're still going to have problems running the factory tune within the bounds of the factory load scale. Cams, different displacement/rod ratio, etc. I'm just lucky that the GTIII-SS with wastegate boost + CA compliance cats is pretty much equivalent to stock turbos. When I have actual space I can finally get it tuned and modify the fuel system for flex fuel to 100% handle any detonation concerns when cranking the boost to whatever those dinky turbos can put out.
    • I would say no, why, because my daughter, who also lives in Goulburn, hasn't recommended us going there Pity, as we miss all the German joints around in Sydney, actually, the restaurants are the only thing I really miss about Sydney, and a special mention to Ishibanboshi at Bondi Junction, their Kara-age Don is heart cloggingly deliciousness (always added a special boiled egg...or 2) 😋 
    • Does that German restaurant still exist in the old place out the NW end of Goulburn? When I say "out the NW end of"...I am really being vague. It was 1997 when I was last there, and the only point of reference I can recall is that it was on the opposite side of the main drag from the big merino. And when I say "opposite side of the main drag", I don't mean "on the main drag". It was either a couple of streets back from there, or might have even been out in the sticks a bit further. Was an old farm building or mill or somesuch. And when I say "the big merino" I might actually be thinking of a completely different part of town, because I just looked on maps and the big bugger is not where I remembered him to be! The food was good, consisting largely of various German mystery-meat sausage/loaf things and kartofflen.
×
×
  • Create New...