Jump to content
SAU Community

Recommended Posts

i couldve got you splitfires for 550 delivered...

You could have said that earlier ya cheeky bugger... Luke_ENR34 has been discussing obtaining splitfires in several threads over the last few weeks...

I would've been keen for a set too, although i just installed a set of supersparks an hour ago...

I'm running 6's in mine.....wondering if I should be running 7's instead now.

I've heard some peeps go even colder to an 8 or 9 even, but I assumed they got more track time

Once over ~270rwkw step up to the 7's. 350rwkw then I'd look at the 8's but then your in to easy plug fouling territory.

I run the BKR7E's, most places can only get the BKR7E-11's so grab them and gap them down.

I have no issues with plug fouling poor starting or plug fouling when cold.

The 6's were coming out looking a tad hot for the power its making; the 7's look perfect. :laugh:

I get around 30,000km's out of mine but thats really pushing them. They start to look worn at 20,000km's but don't seem too cause problems (hard starting and the odd pop) until 30k.

so ,

i was opening my door of my car and i saw something shoot past , went out on to the foot path and it was a koala , so i ran inside and grabbed my dslr and chased after him (was quite funny , a koala running up the street and me chasing it)

anyways he climbed into a small tree up the corner so i took about 50 photos of him and here is one of em

35a877s.jpg

shot at 50mm 1.8

so ,

i was opening my door of my car and i saw something shoot past , went out on to the foot path and it was a koala , so i ran inside and grabbed my dslr and chased after him (was quite funny , a koala running up the street and me chasing it)

they are bloody angry things hey, ppl over seas come here and get attacked by them coz they think their good to hold on to for a while hahahaha :laugh: silly non aussies :P

Joel, on the topic of NKG plugs, can u get them pre-gapped to 0.8mm or do they only come in 1.1

All plugs for example.

BCPR6E or BKR7E are pregapped to 0.8mm.

They can be had from some stores but often need to be ordered in.

You can grab the BCPR6E-11 or BKR7E-11 which are pregapped to ..... 1.1mm and then gap them down :laugh:

I prefer to grab the 0.8mm pregapped plugs as the strap appears to be slightly shorter so the gap is more consistent even at 0.8mm to what the 1.1's are.

In saying that I haven't noticed any difference between 0.8 and 1.1's gapped down to 0.8mm. Currently I'm running BKR7E-11 gapped down to 0.8mm's.

All plugs for example.

BCPR6E or BKR7E are pregapped to 0.8mm.

They can be had from some stores but often need to be ordered in.

You can grab the BCPR6E-11 or BKR7E-11 which are pregapped to ..... 1.1mm and then gap them down :laugh:

I prefer to grab the 0.8mm pregapped plugs as the strap appears to be slightly shorter so the gap is more consistent even at 0.8mm to what the 1.1's are.

In saying that I haven't noticed any difference between 0.8 and 1.1's gapped down to 0.8mm. Currently I'm running BKR7E-11 gapped down to 0.8mm's.

cheers Joel,

i have a pile of BCPR6E-11 sitting here on my desk. i know what you mean about the long strap... i'll gap em down and get em in my car this weekend (my plugs are pretty foul).

i'll just continue getting these instead of looking for pre-gapped ones

All plugs for example.

BCPR6E or BKR7E are pregapped to 0.8mm.

They can be had from some stores but often need to be ordered in.

You can grab the BCPR6E-11 or BKR7E-11 which are pregapped to ..... 1.1mm and then gap them down :laugh:

I prefer to grab the 0.8mm pregapped plugs as the strap appears to be slightly shorter so the gap is more consistent even at 0.8mm to what the 1.1's are.

In saying that I haven't noticed any difference between 0.8 and 1.1's gapped down to 0.8mm. Currently I'm running BKR7E-11 gapped down to 0.8mm's.

cheers for that

so I'm currently running the iridiums BCPR6EIX-11 at .8mm......to run 7's, do I have to run BKR's or do they make BCP's.......what's the difference?

cheers for that

so I'm currently running the iridiums BCPR6EIX-11 at .8mm......to run 7's, do I have to run BKR's or do they make BCP's.......what's the difference?

wasn't asking the difference between coppers & iridiums.....the suffix "IX" denotes iridium.

I wanted to know why Cubes uses a different prefix when going colder in plugs.

looking at the NGK site it makes me think they suit different models?!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...