Jump to content
SAU Community

Recommended Posts

No you guys dont understand....I NEED a GTR. It's why i was born.

Oh, you mean like Ash was born to catch Pokemon, and you were born to drive a 33 GTR? i see now! you get dibs on the first 33gtr that comes up, shotgun second.

With fuel being half reasonable I'm seriously considering stepping back in to good ol V8.

This time around with a slight difference - a couple of turbo's hanging off it. ;)

Only issue is it means I'll have to put up with a rattling dash and poor build quality with a car thats done low km's. :S

With fuel being half reasonable I'm seriously considering stepping back in to good ol V8.

This time around with a slight difference - a couple of turbo's hanging off it. ;)

Only issue is it means I'll have to put up with a rattling dash and poor build quality with a car thats done low km's. :S

hahahahaha

a mate of mine built a twin turbo VZ SS ute (outahnd are the plates). it pulls like all hell in every gear, but son of rajab is it tacky

I bought a VS V8 5speed back in 99' that was on the road for 1 year only for the dash to rattle etc.. Drove me mad as it was a basically a bran new car.

---

Ryan both of those cars sitting next to each other looked like they rolled off the factory floor. Unbelievable condition.

finally i think the airport in Bangkok will finally open tommorrow so i can f**kEN come home if not i gotter travel a further 3 hours at 12 am to a military air base to catch a flight at 8am.............i just wanna come home and pick up my car and so Ryan can put my new bakes on........all ive been doin is shopping and wasting money coz im that bored

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...