Jump to content
SAU Community

Recommended Posts

shame on you for constantly playing along! you should have the same rules as Sam Newman, the network gives you a list of words you CANT say. you'd be pretty much limited to: "hi guys" and "cya"

you two couldnt handle muh pie even if i did make it for you :happy:

I disagree, Ruby and I could devour many a pie.

So much pie infact, Van Halen will reform and write a power ballad about the epic amount of pie we can eat...

-D

Yeah ... you're the consistent wasteland postwhore :happy:

Cara, Ben and I only whore when Cara talks about her .... cooking!

agreed. once we were on the same amount of posts i just check and now lookin ova 5000 hahahah wish i could kill time on sau while getting paid for it at work ;)

Do you add mushrooms and onion or is your pie plain?

Cos if its plain u can keep it. Dont want that pie.

-D

oh hell no ben

ok i make these lamb (can use beef) wellingtons that are to die for...........

lamb

shitload of garlic

fine diced onion

rosemary fresh

salt and pepper

gravy

puff pastry

cooked in the oven they are yummmy! wont give way how i cook them tho :happy: but also make good pie mix too

for example

my burger pattie mix also makes for good meatloaf to lol

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...