Jump to content
SAU Community

Recommended Posts

"For a long time, Koreans thought Dr. Wu Jang Choon invented seedless

watermelon, when in fact, he was the first Korean to demonstrated it in

Korea.

He never claimed to be the inventor. He was merely demonstrating the power

of the genetics. However, this revered Korean scientist was falsely

credited (by and amongst Koreans) for decades after his death in 1959.

It is indeed a Japanese scientist who invented it."

On a forum

my wealth of useless info has grown once again :D

surviced my baby today after the absolute beating it got over the weekend and found a pretty major leak looked like break fluid... must have cooked a line... brakes feel very very dodgy.. only went round the block... have to wait for another day off for closer inspectioin.... :D

yes it does, i havnt heard it with his new exhaust will go and visit him tomorrow i think just to say hello :D

The twin 2.5" sounds f**kin awesome, looks just as nice too. I'm now regretting buying the Apexi cat back!!!!

surviced my baby today after the absolute beating it got over the weekend and found a pretty major leak looked like break fluid... must have cooked a line... brakes feel very very dodgy.. only went round the block... have to wait for another day off for closer inspectioin.... :D

we are talking the GTR yea?

not the super offroad mobile

post-31501-1242910746_thumb.jpg

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
×
×
  • Create New...