Jump to content
SAU Community

Recommended Posts

I'm not gay, the guy who feels me is

and guys that wear man scarves.

did glenda end up getting the rotor? if he didnt i know of an s4/5 with a fair bit of awesome shit going for 10k.

and guys that wear man scarves.

did glenda end up getting the rotor? if he didnt i know of an s4/5 with a fair bit of awesome shit going for 10k.

Nope, but the XR4 has left, finally! He's now buying Josh's Silvia, and Josh is buying a 33 by the looks of it, or a DC2 Integra

never fear Josh is here

dave & luke, running with the 33 idea at the moment......cant find shit for a reasonable price except for the blue one, this is the kind of car/look i want (minus the auto)

http://www.carsales.com.au/all-cars/privat...me&__Nne=15

last night a white 31 was into a pole at the start of the express way, looks like they tried to take the entry to the express way too quickly in the wet and went head first into one of the light poles.

Hope it was no one from on here!!!

The boxes aren't THAT expensive, it's the parts you'll need while doing the conversion. Give smooth a buzz and see what they'll charge so you've got a ballpark figure before you even bother. Boy Glenn will love this, a 33 AND auto :)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...