Jump to content
SAU Community

The Sa Wasteland

Cubes

By Cubes,
in South Australia

 Share

Recommended Posts

  • Replies 36k
  • Created
  • Last Reply

Top Posters In This Topic

  • Damo_R34

    2820

  • scandyflick

    2266

  • Madaz

    1919

  • craig R33

    1717

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Ryanrb25
Ryanrb25

i went for a hills run last night in the 31 with the roads very slippery.....was much fun. Had to bed in the bottom end bearings so yea..took it for a strap.

DSTROY
DSTROY

Hey Ryan, do you know how to fit a set of drop spindles to the front of a hilux???

Madaz
Madaz

Dam straight Damo would rather do SAU them heroin gts4 are 4.1 because they share the same parts from the gtr i think r32 gtst is 4.3 because of the lack of torque from the rb20

Posted Images

dark.sky Grand Master

dark.sky

Posted
Posted
Well i work in Hilton(City of west Torrens) and i live in Hillbank, close to Elizabeth........

And my cars lowish(if thats a word) but i can get up driveways....just :D

it's my daily drive so near somewhere near work would be better.

I have the R32 worked on at Prozac at Virginia. That guy rocks, seriously knows his stuff and treats your car with respect which is what I like to see. Doesnt charge the world either. At one stage (dont know his current price) a full dyno diagnosis which he tested for EVERYTHING was $60. He always used to be there Saturday mornings too. While your there check out his muscle cars haha.

Prozac Auto & Dyno

Lot 33 Phineas Street

Virginia 5120

08 8380-8666

Aberax Grand Master

Aberax

Posted
Posted
My mate and I will do your 100k service for roughly $800 including all belts, water pump, cam seal and crank seal and coolent flush.

I already have some belts, they shall be installed when i get my mods done in the next few weeks. How much would you charge for everything else minus the belts?

dark.sky Grand Master

dark.sky

Posted
Posted
extra poverty pack R34

I wonder what model it is then, because the car it came out of has GT badges and auto climate control etc. So is there a 20 GT and a 25 GT? Must admit the one it came out of looks neat with Nismo front bar, R32 GTR rims and a Nardi wheel :D

Luke_ENR34 Grand Master

Luke_ENR34

Posted
Posted
I already have some belts, they shall be installed when i get my mods done in the next few weeks. How much would you charge for everything else minus the belts?

we shall work out a price for everything to be done at once

Aberax Grand Master

Aberax

Posted
Posted
we shall work out a price for everything to be done at once

I am leaning towards getting Horse Power In A Box to do everything, that way i don't have to worry about it getting towed somewhere to get tuned. But if you tell me a good price i may get you to do it.

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      S1 rb25/s14 starting problem

      By Duncan · Posted

      Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Waders360
      M35 Brake caliper replacement

      By Waders360 · Posted

      Sorry. Front brake calipers
    • MBS206
      S1 rb25/s14 starting problem

      By MBS206 · Posted

      Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...