Jump to content
SAU Community

Recommended Posts

18x9 +20 and 18x10+18. I seen the car your getting yesterday with some CE28s but in a smaller size.. Looked okay but no where near as much dish as XD9's. There is nearly 100mm of dish on the rear!

how much for said rims?

dang, that's right .... there is no way they would fit .... the rears are 65mm wider than stock - they would hang about 3cm out of the guards :) .... 33mm wider than stock is the perfect number I am after, so 10" rims would need to be offset of +50

Yeah the CE28Ns I have priced and chosen don't have anywhere near as much dish as I would like, but they will have about 35mm dish which is the best I can hope for with this type of car.

EDIT!! Damo beat me too it

wheels on the Stag are already porn, 19" Racing harts FTW!! I was thinking for the 32, over the 34 rims now.

ATTESSA will chuck a hissy fit if you run staggered widths because no matter how hard you try you won't be able to achieve the same rolling diameter.

Don't believe me have a play;

http://www.1010tires.com/tiresizecalculator.asp

Edited by D_Stirls

because of the different stretch you will actually be running different rolling diameters so you will be slowly killing your clutches, the good thing is because the 32's don't run any preload you won't be wearing them as quickly as you would be with a 33 or 34 that run a proload.

Edited by D_Stirls
anyone know of a plastic welder in sa?

yeh i do mate

BUMPER TO BUMPER CRASH REPAIRS off tapleys hill road at Royal park

he did a great job on my series 1 m-spec bumper cutting out the middle section out and instead of leaving the cut out bit on the sides open he plastic welded a section in and it now looks flush

he is located in the western suburbs

how much for said rims?

Not cheap. So if your looking for <$2,500 no chance.

dang, that's right .... there is no way they would fit .... the rears are 65mm wider than stock - they would hang about 3cm out of the guards :) .... 33mm wider than stock is the perfect number I am after, so 10" rims would need to be offset of +50

Yeah the CE28Ns I have priced and chosen don't have anywhere near as much dish as I would like, but they will have about 35mm dish which is the best I can hope for with this type of car.

That's half the fun, making them fit. Camber might help tuck them in aswell.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • If you mean the alarm immobiliser; theyre internal to the alarm itself which makes that difficult; I couldnt even see where he put it; its not in the same place as last time; but with all black wiring it might be very challenging to trace  I had someone turn the key for me as I know it only primes for a couple of seconds As my post above; I am getting no voltage to the pump at all; but I am testing continuity of the power line (SB) from the pump plug to the relay fine. As well as the negative from the pump plug to a 12V constant.    Yeah; he blammed the no start on a bad battery; said I needed to get a new battery and it'll start. Turns out the battery drained because the tail lights had been on for half the day during the install (the rubber cushion on the brake switch gave out while he was testing it as I have a picture of the car from that morning with the tail lights off..i've replaced that). The battery was turning over the engine just fine for a long time; but got low since lights were draining it so it was too low to test a start after he finished. I bought a new one on his advice...$250 wasted. My original battery charged up just fine and is healthy.    It was running perfectly fine when I messed up the old alarm (programmed out the remotes). He couldnt start it after removing the old alarm; my assumption is that when he unhooked it; he didnt bridge the circuit back when trying to start it. Its always been perfectly fine. The ECU swap and pump were 2 years ago. It's never missed a beat in that time. 
    • This is a big issue for me without the diff. I just have zero drive from the passenger side when drivers side has no traction. Bec's parents place has a crazy steep driveway with odd camber and I have never been able to get up. My bro-in-law's 130i with an (unknown brand) LSD gets up fine as does their dad's Hiace. My car stays at the bottom. We have other odd camber roads around here as we're elevated a bit and if it's raining I can get totally stuck around some hairpins. 
    • Yeah, I am super excited for this.
    • Was the car running before he touched the car?
×
×
  • Create New...