Jump to content
SAU Community

Recommended Posts

Spotted N15MO at underwood rd yesterday.. wave at you but not sure u saw it.. i'm in little black rav

Spotted gunmetal R32 GTR (836 KGV) at Gateway --> Wynnum rd this arvo... sure ur stereo are pumping hard enough.. :laughing-smiley-014:

Spotted N15MO at underwood rd yesterday.. wave at you but not sure u saw it.. i'm in little black rav

I don't think I would have noticed if you were in rav :D

Spotted OMR33, silver 33 driven by a HAC :P

Also 666DAN heading towards Calamvale

I don't think I would have noticed if you were in rav :D

It's only when you sit behind him at a set of lights, he starts reversing the damn thing towards the front of the 34, and then you see the SAU sticker, that you notice it's him... lmao. Cheeky bugger. :/

Spotted Reggie RWD34 last weekend on the cunningham hway near yamanto. I was in bro's R31 coupe heading the other way. Would've been saturday morning cos bro and i did a macca's breaky run.

i keep seeing almost daily here in redcliffe a red r32 gtr wtih gold and silver rims, with female driver :/

and also spot atleast twice a week a silver r32 gtr with female driver

It's only when you sit behind him at a set of lights, he starts reversing the damn thing towards the front of the 34, and then you see the SAU sticker, that you notice it's him... lmao. Cheeky bugger. :)

Hahaha.. i will try it on John next time... :P

I spotted N15MO again at Mc Cullough st this morning around 11am.. too bad he was in the opposite direction.. :P

spotted a silver 34 GTt on Brookes street this arvo at the marine supply shop in the valley, then saw a White R34 GTR with red personalised plates on Ann street the valley at about 1:30

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...