Jump to content
SAU Community

Recommended Posts

Hello,

I think this might be my first post but any way i have problems :D

The car taking ages to turn over when cold and not as long when hot. When its cold it takes many pumps of the pedal and 2 or 3 turns of the key as to not kill the starter.

When the car is hot its the similar but doesnt need as much pushing of the pedal to fire.

I changed the spark plugs thinking that it might be them....but no

Changed the fuel filter....but no.

Tried taking air-filter off to start car....but no.

The car doesnt feel down on power so not the fuel pump? it's only a starting issue.

Don't know what else i can try? so im looking for suggestions.

The car does have a Mines ECU (which i was stoked to find) but it hadnt effected the starting before. Also has a 3 inch off the dump pipe, CAT and a choking blitz muffler on the back. Other than that, it's stock.

It's been a couple of weeks like this now.

Im after any ideas any of you might have.

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/198298-2000-stagea-s-tune-starting-issue/
Share on other sites

cold days/nights my car is the same, doesnt fire, plugs are fine etc, everything has been serviced, hot days its fine. New pump will go in soon and will be checking fault codes when the informeter arrives... let me know how you go. I didn't gap my plugs down, could that be it?

Now winter is over i have no probs :D

Edited by Ryan1600

when i first got my car i had heaps of problems getting her to start to the point it would take you 5 or 6 pushes on the pedal while you were trying to start it to actually get it going.... my problem was the fact the compliancer had run her out of petrol...2 or 3 weeks later when i had good fuel in her she was fine...now 12months down the track still no problems at all *crosses fingers*

when i first got my car i had heaps of problems getting her to start to the point it would take you 5 or 6 pushes on the pedal while you were trying to start it to actually get it going.... my problem was the fact the compliancer had run her out of petrol...2 or 3 weeks later when i had good fuel in her she was fine...now 12months down the track still no problems at all *crosses fingers*

I keep mine over half a tank with 98 or 100RON

You shouldn't be pumping the pedal on ANY fuel-injected car when you're starting it - it's all controlled electronically, so there's no need for you to try and add more fuel to get it started. This might be part of the problem.

Also, have you checked the small in-line fuel filter near the tank? That often gets clogged first as it's the nearest filter to the tank, so have a look to see if there's anything blocking it.

Oh, and like Kirstie, I never let my fuel level drop below a quarter tank - when the level gets that low there's more of a chance that it the pump will pick up all of the crap that sits on the bottom of the tank, and then your filters will get clogged more quickly.

You shouldn't be pumping the pedal on ANY fuel-injected car when you're starting it - it's all controlled electronically, so there's no need for you to try and add more fuel to get it started. This might be part of the problem.

Also, have you checked the small in-line fuel filter near the tank? That often gets clogged first as it's the nearest filter to the tank, so have a look to see if there's anything blocking it.

Oh, and like Kirstie, I never let my fuel level drop below a quarter tank - when the level gets that low there's more of a chance that it the pump will pick up all of the crap that sits on the bottom of the tank, and then your filters will get clogged more quickly.

on a cold day, pumping is the only way to start it, could be TPS? Also primed the pump a few times before starting, doesn't make a difference

pumping the pedal - yeah.. not a good idea on an EFI car. the only time you should be screwing with the accelerator on startup is if you think the car is " flooded" with fuel .

opening the throttle body butterfly valve will allow more air inside and hopefully get rid of some of the excess fuel vapours and also allow a bit more air in there so that the mixture will eventually fire.

have you tried changing the heat range of your plugs? ie go hotter or colder?

what do the plug tips look like when you take them out .. can you show us a pic?

can you hear the fuel pump prime?

is the edge of the butterfly valve in the throttle body clean? or is it gunked up?

from what I understand ( least on sr20's / my RB knowledge is still on a learning curve) there is a small pin hole that lets a bit of air past hte butterfly valve on idle - and maybe check your idle air control valve? they sometimes get gunked up and need a clean

where exactly is that filter?

Some EFI cars have them, not all - haven't checked the Stagea, so I don't know if there is one there or not. It's usually in the line just after where the fuel lines come out of the tank. My old man's Camry (from way back when) had one that got clogged on the way down to Melbourne one year which had him scratching his head for quite a while until it was pointed out by someone else.

I've seen it on a few cars, but I couldn't confirm if the Stagea has one or not as I've never checked for it.

or if you dont want to get the fuel injectors cleaner you can pump United fuel Boost 98 which is able to clean the lines cos of the ethanol added into it. Im using boost 98 most of the time. If i have the coupond fuel vouchers i will use it.

pumping the pedal - yeah.. not a good idea on an EFI car. the only time you should be screwing with the accelerator on startup is if you think the car is " flooded" with fuel .

opening the throttle body butterfly valve will allow more air inside and hopefully get rid of some of the excess fuel vapours and also allow a bit more air in there so that the mixture will eventually fire.

have you tried changing the heat range of your plugs? ie go hotter or colder?

what do the plug tips look like when you take them out .. can you show us a pic?

can you hear the fuel pump prime?

can hear it prime, then stop, turn acc off, then back on to reprime... When i pull everything apart to clean it, any directions as to what i am cleaning, what to use to clean it, and can i stuff any adjustments whilst doing it?

-Ryan :D

Fuel pump switches off once there is pressure in the system and the engine is not running so no need to keep pumping to maintain pressure. Switching it on and off multiple times won't make any difference, the fuel system is either pressurised, or not... Happening when it's cold suggests it might be a sensor playing up... Check error codes would be a good start.

well I dont know for sure..( as I have only cleaned the IAC valve on the pulsar ) but I would assume the same thing applies to the RB motors.

what do the sparkplugs look like? is the colour ok ?

can hear it prime, then stop, turn acc off, then back on to reprime... When i pull everything apart to clean it, any directions as to what i am cleaning, what to use to clean it, and can i stuff any adjustments whilst doing it?

-Ryan :D

Update....

I know you're not supposed to pump the pedal, but if i didnt it would probly just crank all day and not fire. Sometimes it will start first go but rarely.

It feels like its starting to lose some down low power, but is almost as fast at hight revs 4500+

Can't hear fuel pump prime, ive never been able to hear a stock fuel pump prime in any car.

Is it possible the fuel pump could be dying? A mates sprinter would start but stall past 3000rpm = stuffed fuel pump. Another mates silvia would lose power at 5000rpm and stall pretty much = stuffed fuel pump again.

But mine not getting fuel at start up = stuffed fuel pump?!?

A dirty/rooted O2 sensor do it?

The plugs that i took out of the car, the tips were white possibly too hot?. not fouled and black.

I might check out the throttle body tomorrow, when i did the plugs there was some black shite (oil/dirt) on the cooler piping inner walls. I just assumed it was a crud build up.

Thanks for your suggestions. :P

Edited by Whooby
  • 3 weeks later...

Update:

Tried a larger fuel pump, good for up to 500HP - No change, bit too much fuel for a stock engine.

Could it be a crank angle sensor perhaps? once the engine fires there is a Tick Tick Tick then stops. Not sure what it is yet.

Any help please :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...