Jump to content
SAU Community

Recommended Posts

Man I feel so skinny, feel like going bulk again... lost so much size

was experimenting with lighting so they're a bit showy - last pics im gonna post, nohomo

th_1IMG_1503_zpsbd5e851c.jpg th_1IMG_1507_zpscd1daf24.jpg

76kg atm, possibly a bit less.

As for lean gains, not sure hey. I usually just eat what I want when bulk... Been cutting at 2000 then 1950 then now 1900 cals a day. Would say 0.5kg/week loss. Started cut at 82kg ish.

I take fitbodies WPI isolate and its cheap too. Basically no carbs/fat, high protein.

Link here: http://www.ebay.com.au/itm/281200336548

Edited by 10 4

Regardless of goals, my point was that if he had a few girls comment on his topless state or noticed an increase in attention from the ladies he would probably quickly lose sight of his bulking goals and find the extra motivation to stay clean diet :P

why would you want to impress women if you have a partner :/

How do we know if 10 4 has a partner? Compliments from people are still nice even if you have a partner.

doesn't mean you need to impress them.

Given the nature of the work, I say he does.

You've got jealous GF mode switched on, guys are VERY good at separating work from everything else. It's just a job.

I used to work at Clints Crazy Bargains during Uni, It did not make me start wanting to shop there, the products were still shit.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...