Jump to content
SAU Community

Recommended Posts

well you've got them now so might as well use them - it is amusing how much their articles shill them though.

I will be using them, sorted out my timetable:10am and 3pm mag 10, plazma before and during workout and mag 10 straight after workout and before bed

What's it meant to do?

Mag-10 is used for protein pulsing, (science based dosing strategy for making the body hyper responsive to high protein utilization and producing maximum anabolic effect) which is achieved by three to four amino acid spikes per day.

Plazma contains di and tripeptides and carbohydrate complex to increase metabolic rate and create a pump effect. It stimulates enhanced muscle responsiveness and is also used post workout for recovery

I swear these unsubstantiated marketing claims prey on people (and scientists as an extension) not fully knowing how the body actually works

I feel like their marketing department would be ten times the manpower of their r&d guy / dog

If it wasn't for the Hype and support from companies that have a financial interest most supplements wouldn't make it off the shelves.

As for protein loading.

From my research and personal experience here is some stuff to mull over and critique.

Have your high protein diet for 3 weeks, then cut out all of your extra protein supps for 1 week (I do this on my deload week), then after that week go back to your high protein diet.

The idea is your body is use to high protein, then it get gets starved for it, then it gets it again, your body then goes into starvation mode and stores the extra protein in your body, rinse and repeat.

I've read that people cycle their protein and do 6 on 1 off or other combos.

The science behind it is from AIDS and cancer patients that needed to keep adding weight, they used the old bad diet routine of how people diet for 3 weeks good then lose it for a week and end up gaining weight in the long run.

But then I'm $ure that the $upplement companie$ know what they are doing.

Hmmm, reminds me of "Power thirst".

I swear these unsubstantiated marketing claims prey on people (and scientists as an extension) not fully knowing how the body actually works

I feel like their marketing department would be ten times the manpower of their r&d guy / dog

T Nation have been shat on before for their BS marketing claims on their supplements. It's unfortunate because they have some legit authors with good articles, but then post idiots who write the polar opposite and all of the product placement stuff really detracts from the website.

SinistaGTR's Sent me a pm I have some question

To asked you about Nismo Led tail lights. Thanks

Take 5 grams of Nismo led tail lights morning and night for best results.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
    • yeh they are 235/45/17 up front and 255/40/17 in the rears. I still didn't get my answer if i can fit a 18x9 up front. I want to get 4 of this and see if they will fit before committing as they didn't see an 18x8 as an option but there is a 18x9.5 also.   Enkei RS05-RR 18x9 35mm ET 5x114.3 75.0 Bore Matte Gunmetal Wheel
×
×
  • Create New...