Jump to content
SAU Community

Recommended Posts

We are now offering VERDE KAOS to SAU users at discounted prices.

BLACK/CHROME DISH

Tn_55kaos-blk-chrome.jpg

18" PACKAGE $1700(RRP $1900)

20" $2600(RRP $2900)

(18" fit GTS & GTR, 20" fit GTS ONLY)

CHROME

Tn_55kaos-chrome.jpg

18" PACKAGE $1600(RRP $1800)

20" $2400(RRP $2800)

(18" fit GTS ONLY, 20" fit GTS ONLY)

HYPER SILVER

Tn_55Kaos-hyp%20silver.jpg

18" PACKAGE $1300(RRP $1500)

20" $2100(RRP $2500)

(18" fit GTS ONLY, 20" fit GTS & GTR)

Tyre brands depend on sizes applicable

Link to comment
https://www.sau.com.au/forums/topic/202174-verde-kaos-special/
Share on other sites

Hey mate im after some nankangs NS2 in 265/35r18 how much each PM if you want i need 4.

Hey mate we dont sell Nankang in that size, if your after cheap i have Kumho, can do them $200 ea fitted/balanced, otherwise $275 for 265/275 japanese tyres.

what size width on front and rear wheels? offset? how big of the dish? (for 18" HYPER SILVER)

cheers

18X8 (one width) +20/38 offset

20X8.5 (one width) +20/38 offset

18" dish is approx 2"

  • 4 months later...


  • Similar Content

  • Latest Posts

    • R34DE as in R34 with an RB25DE? So did you get this? Or you planning to?  I'm not really sure what you're saying. 
    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
×
×
  • Create New...