Jump to content
SAU Community

Recommended Posts

Thanks for all the replies! Where to start...guess i started learning about imports and engines through my boyfriends and their mates. I picked things up quickly and just found that when it came to digging into an engine i was always up for getting my hands dirty. The passion manifested from there started learning more and more about how everything works with engines and turbos and how the differences between various engines produced more or less power. I'm actually a nursing student in S.A. lol and alot of people were surprised when i came out of the closet (so to speak) and bought my baby. So cheers again and heres some pics.

post-47417-1202443935_thumb.jpg

post-47417-1202444004_thumb.jpg

post-47417-1202444075_thumb.jpg

heya cass welcome! thats a pretty full on BNR32 u got there... kinda makes mine look..... weak.... baahahaha

what is it with you guys and ladies joining the forum... first question is always pics!

ull find us a bunch with alot of knowledge in every department and always happy to help... just avoid the forum during school holidays.. u'll find out why!! puts us to shame!!

all the best for u and your stunning new Bnr32 aka godzilla

also... mods and dyno results??

peace

mark

Edited by jenkies

wow that bonnet is a pretty nice design. do you know where the previous owner got it (I'm assuming they put it on) or what model it is if you don't mind me asking?

car's hawt. good buy.

Welcome welcome!!

Nice to see more girls in GTR's!

I'm a 22 year old chick as well and have an R34 GTR :thumbsup: We should start a GoddessZilla Club hehe

Best wishes!!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...