Jump to content
SAU Community

Recommended Posts

  • Replies 410
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Hey all

Considering entering tomorrow morning if there is still space, my license is still good from last year and i'm happy to turn up early. Enjoyed it so much last year!

Unfortunately the clutch is on the way out and I have a few suspension bushes playing up. Given that, I would prefer to run on the wet skidpan and perhaps a couple of runs on the back track (provided clutch holds up).

So just wanted to confirm that the wet skidpan is in? or isn't it? If not i'll probably sit this one out and spectate. Either way see you tommorrow! Looking forward to it.

sorry Leroy, it's the dry skid pan..

we only did the wet one last year cos the stay upright ppl's had taken the dry one on us.

psml at the dildo :thumbsup: good to see my directions to the right places in fyshwick worked out :(

sorry Leroy, it's the dry skid pan..

we only did the wet one last year cos the stay upright ppl's had taken the dry one on us.

psml at the dildo :thumbsup: good to see my directions to the right places in fyshwick worked out :(

You could have sent them to mitchell. There are lots of porn shops out there and the directions invlolve only 3 corners :(

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...