Jump to content
SAU Community

Recommended Posts

im doin wat he is^^

car's got no seats/carpets atm lol

next time...

so mine has 2 seats an floor carpet.. u soft 34 boys lol..

i will be there, yes im at my girlfriends house and yes i will be coming in work clothes...

can we have a meet 2moro night i got blue smoke tyres lol

  • Replies 52
  • Created
  • Last Reply

Top Posters In This Topic

yeah everyone was there....i had trouble finding it cos i didnt realise it was at the back!

sorry to the guys who i said i was coming down to kmart but my friend took ages to rock up! good meeting some of you guys.

Far out, that was a hike!

Just came back from where u guys were..

thought it was organised for the safeway roof top..get there no one is there..

anyway drove past image, bf didnt wana stop coz there was only 3 cars :D

10-12 cars, there for sure... although if your posting at 7:34pm, and the meet was 7:30pm... then you were probably far too early?

Good to meet people, sorry i'll forget a few names though, im a bit hopeless with that :)

See people again soon no doubt in my own car

yeah man. another one.

i think its due to constant compressor surge. even when i back off on light throttle i get it. at high rpm i dont get a woosh from the bov. all i get is high pitched compressor surge

maybe its due to squashing my stock bov and putting a fan screw in the bleeder of it.

oil pressure seems fine. when i boot it goes to about 5. cruising about 4

I wouldnt go off the stock gauge... plus thats reading @ the sender... over @ the turbo is half an engine bay away, could be a blockage in a line or something that wont show up on a gauge etc.

could be comp surge... but i doubt it that soon

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...