Jump to content
SAU Community

Recommended Posts

either the motor drive to shut the valve is stuffed or the valve is stuck, With mine I turned the temp up & down for about a week when it did the same, works fine now and I do it every now and then just to keep it loose.

got the same problem, i thought it might b cause i havent got a aircon in mine anymore so was going to see about getting it blocked up by my mechanic but will definatley turn it up and down first to try close the vent.

if you still got the aircon then my first guess was wrong lol, if so let me know thanks.

peace

got it in my 33 aswell, and my thermostat seems to be out. I can stop air coming through it yough if you press the button which changes the way the air comes in the cabin (the butting with the bent arrow in a car, next to the A/C button) if you have it so the light is on I found it at least stopped the air from coming in.

Turn your aircon on, set it to the coldest temp, turn it off...

The vents open/close somewhere in the middle, 22 degrees is the changeover point I think...

That should fix your problem, otherwise you have a serious malfunction...

i get that all the time hot air .... u can stop it from going hot air by pressing mode and turning the temp down and then pressing OFF it then turns off and goes back to ur feet but this time its cold air...

you guys are champs!!.... i didnt know that its was automatically air comin through.... so just recirc it.... hehehe.... i was gonna say that it turns of if you dont choose that settin but...all good...cheers guys..... how low can people get there air cons/?... coz mine only goes to 18..or is that normal??

cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...